enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Circuit diagram - Wikipedia

   en.wikipedia.org/wiki/Circuit_diagram

   A less common symbol is simply a series of peaks on one side of the line representing the conductor, rather than back-and-forth. Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle ...

3. Electronic symbol - Wikipedia

   en.wikipedia.org/wiki/Electronic_symbol

   An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country, or engineering ...

4. Wiring diagram - Wikipedia

   en.wikipedia.org/wiki/Wiring_diagram

   A set of wiring diagrams may be required by the electrical inspection authority to approve connection of the residence to the public electrical supply system. Wiring diagrams will also include panel schedules for circuit breaker panelboards, and riser diagrams for special services such as fire alarm or closed-circuit television or other special ...

5. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   Black, Red and Blue are used for hot wires and White is used as the neutral wire in a 120/208 V circuit. Brown, Orange and Yellow are used as hot wires and gray is used as the neutral wire in a 277/480 V. For grounding, regardless of the voltage, Green (or a bare wire) is used.

6. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   Connectors on this cable would be designated: 1A1W35P1; 1A1W35P2; ASME Y14.44-2008 continues the convention of Plug P and Jack J when assigning references for electrical connectors in assemblies where a J (or jack) is the more fixed and P (or plug) is the less fixed of a connector pair, without regard to the gender of the connector contacts.

7. AC power plugs and sockets - Wikipedia

   en.wikipedia.org/wiki/AC_power_plugs_and_sockets

   These are used for both 220-volt and 127-volt regions of the country, despite the IEC 60906-2 recommendation that NEMA 5-15 be used for 120 V connections. There are two types of sockets and plugs in NBR 14136: one for 10 A, with a 4.0 mm pin diameter, and another for 20 A, with a 4.8 mm pin diameter. [13]

8. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

9. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.