Search results
Results from the WOW.Com Content Network
The 64 MB [6] of sound memory on the Sound Blaster X-Fi Fatality Pro sound card is built from two Micron 48LC32M8A2 SDRAM chips. They run at 133 MHz (7.5 ns clock period) and have 8-bit wide data buses. [10] Originally simply known as SDRAM, single data rate SDRAM can accept one command and transfer one word of data per clock cycle.
These DMA channels performed 8-bit transfers (as the 8237 was an 8-bit device, ideally matched to the PC's i8088 CPU/bus architecture), could only address the first (i8086/8088-standard) megabyte of RAM, and were limited to addressing single 64 kB segments within that space (although the source and destination channels could address different ...
Intel 8237A-5, used on the original IBM PC motherboard Pinout. Intel 8237 is a direct memory access (DMA) controller, a part of the MCS 85 microprocessor family. It enables data transfer between memory and the I/O with reduced load on the system's main processor by providing the memory with control signals and memory address information during the DMA transfer.
A von Neumann architecture scheme. The von Neumann architecture—also known as the von Neumann model or Princeton architecture—is a computer architecture based on the First Draft of a Report on the EDVAC, [1] written by John von Neumann in 1945, describing designs discussed with John Mauchly and J. Presper Eckert at the University of Pennsylvania's Moore School of Electrical Engineering.
The IBM PC took a more conventional approach, their adaptor card could support up to four drives; on the PC direct memory access (DMA) to the drives was performed using DMA channel 2 and IRQ 6. The diagram below shows a conventional floppy disk controller which communicates with the CPU via an Industry Standard Architecture (ISA) bus or similar ...
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.
The bit-lines are precharged to exactly equal voltages that are in between high and low logic levels (e.g., 0.5 V if the two levels are 0 and 1 V). The bit-lines are physically symmetrical to keep the capacitance equal, and therefore at this time their voltages are equal. [35] The precharge circuit is switched off.
Single instruction, multiple data. Single instruction, multiple data (SIMD) is a type of parallel processing in Flynn's taxonomy.SIMD can be internal (part of the hardware design) and it can be directly accessible through an instruction set architecture (ISA), but it should not be confused with an ISA.