Search results
Results from the WOW.Com Content Network
The Turbo-Hydramatic or Turbo Hydra-Matic (THM) series was developed to replace both the original Hydra-Matic models and the Buick Dynaflow. In its original incarnation as the Turbo-Hydramatic 400, it was first used in the 1964 model year in Cadillacs. The Buick version, which followed shortly thereafter, was known as the Super-Turbine 400.
Designed for longitudinal engine configurations, the series included 4 forward gears. It was the 4-speed electronically commanded evolution of the 3-speed Turbo-Hydramatic 400, first produced in October 1963. 4L80-Es were optioned only in Chevrolet/GMC pickups, vans, and commercial vehicles, and the Hummer H1.
The TH400 was phased out for the 1980 models, when the A-727 replaced the TH-400 as the only automatic transmission option for both the SJ Wagoneer/Cherokee wagons and the J-10/J-20 trucks. Internally similar to the Chrysler A-727, the case was one-piece, cast with an AMC pattern bellhousing (not interchangeable with a Chrysler pattern A-727).
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
The "MN4" 4T40E is able to handle vehicles up to 4000 lb (1814 kg) GVWR. The final drive ratio can vary depending on the car's curb weight and engine power output. 3.91, 3.63, 3.29, 3.05, 3.69, and 3.42 are all of the available ratios used in the 4T40 (and 4T45) transmission; Made possible by using combinations selected from 3 different sprocket combinations (32/38, 35/35, 33/37) and 2 ...
In Drive at full throttle, it would upshift from low gear to high gear at 60–65 mph (97–105 km/h). Under light throttle, depending on the final drive ratio, it might upshift at 10-15 mph. From 1964-1967, Buick and Oldsmobile versions of this transmission used a torque converter with a variable-pitch stator called Switch-Pitch (by Buick) or ...
The 400 is the only engine that uses a 2.65 in (67.3 mm) main bearing journal and a 2.1 in (53.3 mm) rod bearing journal. The connecting rod was also 400 specific being 5.565 in (141.4 mm) as opposed to the 5.7 in (144.8 mm) rod used in all other small-block Chevrolet engines.
HydraMatic Division calls the Roto a four-range, three-gear HydraMatic. It counts the stator multiplication at 3.50:1 as a first gear, and when road speed and the two coupling halves’ speed match, it counts the same gear with fluid now passing straight through the stator as 2nd gear at 2.93 to one.