Search results
Results from the WOW.Com Content Network
The MacBook and the 13-inch MacBook Pro use a 60 W MagSafe charger, whereas the 15- and 17-inch MacBook Pro use an 85 W version. The MacBook Air used a lower-powered 45 W version. According to Apple, an adapter with a higher wattage than that originally provided may be used without problems. [12]
Users of joint products may start with greater amounts of storage for a limited period: with a LaCie external hard disk drive, 10 GB for one year or with a LaCie USB flash drive, 4 GB for two years. [22] Additional storage may be bought. [23] As of June 2014, the referral system was shut down due to the new paid-only policy.
In computing, an expansion card (also called an expansion board, adapter card, peripheral card or accessory card) is a printed circuit board that can be inserted into an electrical connector, or expansion slot (also referred to as a bus slot) on a computer's motherboard (see also backplane) to add functionality to a computer system. Sometimes ...
2003 Launch of 500 GB external Hard Drive: LaCie Big Disk; portable drives designed by F.A. Porsche line of storage solutions; first Triple Interface Hard Drives. [citation needed] 2004 1 TB external Hard Drive the LaCie Bigger Disk. [citation needed] 2009 LaCie acquires Caleido, a peer-to-peer storage start-up, with their product named Wuala.
An integrated SuperDrive shown on the right side of a MacBook Pro. Once the use of floppy disks started declining, Apple reused the trademark to refer to the optical drives built into its Macintosh models, which could read and write both DVDs and CDs. The early 2001 release of the Power Mac G4 was the first Macintosh to include a SuperDrive. [1]
On a parallel SCSI bus, a device (e.g. host adapter, disk drive) is identified by a "SCSI ID", which is a number in the range 0–7 on a narrow bus and in the range 0–15 on a wide bus. On earlier models a physical jumper or switch controls the SCSI ID of the initiator ( host adapter ).
SCSI hard drives showing 80-pin SCA connector (top), and separate 68-pin and power connectors plus configuration jumpers (bottom) SCSI backplane with 80-pin SCA connectors. Hard Drives are mounted on proprietary hot-swappable caddies. Single Connector Attachment, or SCA, is a type of connection for the internal cabling of Parallel SCSI systems ...
Historical Word serial interfaces connect a hard disk drive to a bus adapter [b] with one cable for combined data/control. (As for all early interfaces above, each drive also has an additional power cable, usually direct to the power supply unit.) The earliest versions of these interfaces typically had an 8 bit parallel data transfer to/from ...