Search results
Results from the WOW.Com Content Network
The commonly known phases solid, liquid and vapor are separated by phase boundaries, i.e. pressure–temperature combinations where two phases can coexist. At the triple point, all three phases can coexist. However, the liquid–vapor boundary terminates in an endpoint at some critical temperature T c and critical pressure p c. This is the ...
The point at the very top of the dome is called the critical point. This point is where the saturated liquid and saturated vapor lines meet. Past this point, it is impossible for a liquid–vapor transformation to occur. [3] It is also where the critical temperature and critical pressure meet.
Critical point: 369.522 K (96.672 °C), 42.4924 bar ... Liquid properties Std enthalpy change of formation, ... Propane is highly temperature dependent. [3]
As the critical temperature is approached (300 K), the density of the gas at equilibrium becomes higher, and that of the liquid lower. At the critical point, (304.1 K and 7.38 MPa (73.8 bar)), there is no difference in density, and the 2 phases become one fluid phase. Thus, above the critical temperature a gas cannot be liquefied by pressure.
The heat of vaporization diminishes with increasing temperature and it vanishes completely at a certain point called the critical temperature (T r = 1). Above the critical temperature, the liquid and vapor phases are indistinguishable, and the substance is called a supercritical fluid.
The equilibrium conditions are shown as curves on a curved surface in 3D with areas for solid, liquid, and vapor phases and areas where solid and liquid, solid and vapor, or liquid and vapor coexist in equilibrium. A line on the surface called a triple line is where solid, liquid and vapor can all coexist in equilibrium. The critical point ...
This temperature is called the boiling point of the liquid mixture at the given pressure. (It is assumed that the total pressure is held steady by adjusting the total volume of the system to accommodate the specific volume changes that accompany boiling.)
In mixtures of substances, the bubble point is the saturated liquid temperature, whereas the saturated vapor temperature is called the dew point. Because the bubble and dew lines of a zeotropic mixture's temperature-composition diagram do not intersect, a zeotropic mixture in its liquid phase has a different fraction of a component than the gas ...