Search results
Results from the WOW.Com Content Network
In many modern boats, the heads look similar to seated flush toilets but use a system of valves and pumps that brings sea water into the toilet and pumps the waste out through the hull (in place of the more normal cistern and plumbing trap) to a drain. In small boats the pump is often hand operated.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
A flush toilet (also known as a flushing toilet, water closet (WC); see also toilet names) is a toilet that disposes of human waste (i.e., urine and feces) by collecting it in a bowl and then using the force of water to channel it ("flush" it) through a drainpipe to another location for treatment, either nearby or at a communal facility.
The company was founded by William Elvis Sloan in Chicago, Illinois in 1906 with the introduction of the Royal flushometer, a valve to release a measured amount of water to flush a urinal or toilet. Initial sales were very poor: only a single Royal model flushometer was sold in 1906, and two in 1907.
A narrow passageway leads from the main water supply into the pressure chamber. It is the narrowness of this passage that meters the flow by slowing repressurizing of the pressure chamber after the action of a flush. The diaphragm technology allows the flush valve to open and let water into the bowl. A main cylinder valve operates up and down.
A dual flush toilet; note the two buttons at the top of the cistern. A dual flush toilet is a variation of the flush toilet that uses two buttons or a handle mechanism to flush different amounts of water. The purpose of this mechanism is to reduce the volume of water used to flush different types of waste.
When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.
A low-flush toilet (or low-flow toilet or high-efficiency toilet) is a flush toilet that uses significantly less water than traditional high-flow toilets. Before the early 1990s in the United States, standard flush toilets typically required at least 3.5 gallons (13.2 litres) per flush and they used float valves that often leaked, increasing their total water use.