Search results
Results from the WOW.Com Content Network
Tacking or coming about is a sailing maneuver by which a sailing craft (sailing vessel, ice boat, or land yacht), whose next destination is into the wind, turns its bow toward and through the wind so that the direction from which the wind blows changes from one side of the boat to the other, allowing progress in the desired direction. [1]
A tack is the windward side of a sailing craft (side from which the wind is coming while under way)—the starboard or port tack. Generally, a craft is on a starboard tack if the wind is coming over the starboard (right) side with sails on port (left) side. Similarly, a craft is on a port tack if the wind is coming over the port (left).
Boats on a port tack shall keep clear of boats on starboard tack (Rule 10). When boats are on the same tack and overlapped, the boat to windward (the boat closest to the wind) shall keep clear of a leeward boat (Rule 11). When boats are on the same tack and not overlapped, the boat that is astern shall keep clear of the boat ahead. (Rule 12).
However, under sail on a given tack, the corner to which the spinnaker sheet is attached is called the clew, and the corner attached to the spinnaker pole is referred to as the tack. [20] Tack – The tack is the corner on a fore-and-aft sail where the luff and foot connect [8] and, on a mainsail, is located where the boom and mast connect.
The ship is close-hauled and the sail is now controlled by the tack rather than the sheet. The tack of a square-rigged sail is a line attached to its lower corner. [ 1 ] This is in contrast to the more common fore-and-aft sail, whose tack is a part of the sail itself, the corner which is (possibly semi-permanently) secured to the vessel.
If the destination is upwind but the sailboat goes fastest heading away from this direction, this poses a significant problem: how to choose tack headings with the best tradeoff between maximimizing speed and minimizing distance. The ability to define an efficient tacking route is an important issue in sailboat racing, and for recreational sailing.
As the boat tacks they change over. Another function of the running backstay is to adjust the tension of the forestay to suit the sailing angle and sea condition. In general, during a hard beat when the boat sails very close to the wind, the running backstay is tightened to increase the tension of the forestay. The genoa is sheeted in.
On cruising yachts, and nearly all racing sailboats, the jib needs to be worked when tacking. On these yachts, there are two sheets attached to the clew of the jib. As the yacht comes head to wind during a tack, the active sheet is released, and the other sheet (the lazy sheet) on the other side of the boat is