enow.com Web Search

  1. Ad

    related to: doorbell transformer with outlet switch and cord holder

Search results

  1. Results from the WOW.Com Content Network
  2. Doorbell - Wikipedia

    en.wikipedia.org/wiki/Doorbell

    Pressing the doorbell button, a single-pole, single-throw (SPST) pushbutton switch momentarily closes the doorbell circuit. One terminal of this button is wired to a terminal on a transformer. A doorbell transformer steps down the 120 or 240-volt AC electrical power to a lower voltage, typically 6 to 24 volts. The transformer's other terminal ...

  3. Electric bell - Wikipedia

    en.wikipedia.org/wiki/Electric_bell

    In residential applications, a small bell-ringing transformer is usually used to power the doorbell circuit. So that bell circuits can be made with low-cost wiring methods, bell signal circuits are limited in voltage and power rating. [3]

  4. Electrical wiring - Wikipedia

    en.wikipedia.org/wiki/Electrical_wiring

    Joints were soldered, and special fittings were used for lamp holders and switches. These cables were similar to underground telegraph and telephone cables of the time. Paper-insulated cables proved unsuitable for interior wiring installations because very careful workmanship was required on the lead sheaths to ensure moisture did not affect ...

  5. Trimline telephone - Wikipedia

    en.wikipedia.org/wiki/Trimline_telephone

    The bulky transformer and the need for a conveniently-placed outlet was criticized by many consumers, but was necessary because of the power demands of the incandescent light bulb. Years later, Western Electric redesigned the Trimline to use a low-power green light-emitting diode (LED) to backlight the dial, which was powered by current from ...

  6. Telephone switchboard - Wikipedia

    en.wikipedia.org/wiki/Telephone_switchboard

    PBX switchboard, 1975. A telephone switchboard is a device used to connect circuits of telephones to establish telephone calls between users or other switchboards. The switchboard is an essential component of a manual telephone exchange, and is operated by switchboard operators who use electrical cords or switches to establish the connections.

  7. Residual-current device - Wikipedia

    en.wikipedia.org/wiki/Residual-current_device

    A residual-current device (RCD), residual-current circuit breaker (RCCB) or ground fault circuit interrupter (GFCI) [a] is an electrical safety device, more specifically a form of Earth-leakage circuit breaker, that interrupts an electrical circuit when the current passing through line and neutral conductors of a circuit is not equal (the term residual relating to the imbalance), therefore ...

  8. Western Electric hand telephone sets - Wikipedia

    en.wikipedia.org/wiki/Western_Electric_hand...

    This box is typically mounted on a wall or desk-side, and contains an electromagnetic bell ringer and a speech transformer, called induction coil, to connect the telephone to the telephone line wiring. The handset mounting is either a desk-top stand to cradle and secure the handset when not in use, or a small box mounted against a vertical ...

  9. Galvanic isolation - Wikipedia

    en.wikipedia.org/wiki/Galvanic_isolation

    The switching contacts may be normally closed (opening when the coil is energized) or normally open (closing when the coil is energized). Relays do not transmit power like a transformer, but relatively little coil power can control a much higher power circuit, making them a kind of amplifier. They are very widely used for control applications ...

  1. Ad

    related to: doorbell transformer with outlet switch and cord holder