enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Orders of magnitude (length) - Wikipedia

    en.wikipedia.org/wiki/Orders_of_magnitude_(length)

    1.0 mm – 0.03937 inches or 5/127 (exactly) 1.0 mm – side of a square of area 1 mm²; 1.0 mm – diameter of a pinhead; 1.5 mm – average length of a flea [27] 2.54 mm – distance between pins on old dual in-line package (DIP) electronic components; 5 mm – length of an average red ant; 5 mm – diameter of an average grain of rice

  3. List of rail transport modelling scale standards - Wikipedia

    en.wikipedia.org/wiki/List_of_rail_transport...

    Lego trains use a fixed nominal gauge of 37.5 mm (1 + 15 ⁄ 32 in), based on 5-stud track centerlines gauge. [5] [6] [7] The 37.5 mm length is not derived by a certain scale ratio. While HO scale is a 1:87 scale (3.5 mm to 1 foot), resulting in a 16.5 mm (0.65 in) gauge from real life prototype 1,435 mm (4 ft 8 + 1 ⁄ 2 in) standard gauge ...

  4. 6.5mm Creedmoor - Wikipedia

    en.wikipedia.org/wiki/6.5mm_Creedmoor

    The 6mm Creedmoor is a necked-down version of the 6.5mm Creedmoor using 6 mm (.243 inch) bullets, lighter than 6.5 mm bullets with similarly reduced recoil. [30] John Snow at Outdoor Life built a 6mm Creedmoor rifle in 2009 for a magazine article of the wildcat cartridge that appeared in 2010, but the first documented conception of the 6mm ...

  5. Millimetre - Wikipedia

    en.wikipedia.org/wiki/Millimetre

    Different lengths as in respect to the electromagnetic spectrum, measured by the metre and its derived scales.The microwave is between 1 meter to 1 millimeter.. The millimetre (international spelling; SI unit symbol mm) or millimeter (American spelling) is a unit of length in the International System of Units (SI), equal to one thousandth of a metre, which is the SI base unit of length.

  6. 5 mm caliber - Wikipedia

    en.wikipedia.org/wiki/5_mm_caliber

    This is a list of firearm cartridges which have bullets in the 5.00 to 5.99 mm (0.197 to 0.236 in) caliber range. Length refers to the cartridge case length. OAL refers to the overall length of the cartridge.

  7. Agate (typography) - Wikipedia

    en.wikipedia.org/wiki/Agate_(typography)

    It is 5.5 typographical points, or about 1 ⁄ 13 inch (1.94 mm). It can refer either to the height of a line of type or to a font that is 5.5 points. An agate font is commonly used to display statistical data or legal notices in newspapers. It is considered to be the smallest point size that can be printed on newsprint and remain legible ...

  8. List of culinary knife cuts - Wikipedia

    en.wikipedia.org/wiki/List_of_culinary_knife_cuts

    Fine julienne; measures approximately 1 ⁄ 16 by 1 ⁄ 16 by 1–2 inches (0.2 cm × 0.2 cm × 3 cm–5 cm), and is the starting point for the fine brunoise cut. [ 1 ] Chiffonade ; rolling leafy greens and slicing the roll in sections from 4–10mm in width

  9. List of disk drive form factors - Wikipedia

    en.wikipedia.org/wiki/List_of_disk_drive_form...

    8-, 5.25-, 3.5-, 2.5-, 1.8- and 1-inch HDDs, together with a ruler to show the length of platters and read-write heads A newer 2.5-inch (63.5 mm) 6,495 MB HDD compared to an older 5.25-inch full-height 110 MB HDD. IBM's first hard drive, the IBM 350, used a stack of fifty 24-inch platters and was of a size comparable to two large refrigerators.