Search results
Results from the WOW.Com Content Network
Wi-Fi over Coax is a technology for extending and distributing Wi-Fi signals via coaxial cables. As an in-building wireless solution, Wi-Fi over Coax can make use of existing or new cabling with native impedance of 50 Ω shared by a Wi-Fi access point , cabling run, and antenna.
A wireless network interface controller (WNIC) is a network interface controller which connects to a wireless network, such as Wi-Fi, Bluetooth, or LTE (4G) or 5G rather than a wired network, such as an Ethernet network. A WNIC, just like other NICs, works on the layers 1 and 2 of the OSI model and uses an antenna to communicate via radio waves.
Long-range Wi-Fi is used for low-cost, unregulated point-to-point computer network connections, as an alternative to other fixed wireless, cellular networks or satellite Internet access. Wi-Fi networks have a range that's limited by the frequency, transmission power, antenna type, the location they're used in, and the environment. [ 1 ]
Wi-Fi (/ ˈ w aɪ f aɪ /) [1] [a] is a family of wireless network protocols based on the IEEE 802.11 family of standards, which are commonly used for local area networking of devices and Internet access, allowing nearby digital devices to exchange data by radio waves.
In computer networking, a wireless access point (WAP) (also just access point (AP)) is a networking hardware device that allows other Wi-Fi devices to connect to a wired network or wireless network. As a standalone device, the AP may have a wired or wireless connection to a switch or router , but in a wireless router it can also be an integral ...
Wi-Fi microcontrollers enable Wi-Fi connectivity for devices so that they can send & receive data and accept commands. As such, Wi-Fi microcontrollers can be used for bringing otherwise ordinary devices into the realm of the Internet of things .
A patch antenna is a narrowband, wide-beam antenna fabricated by etching the antenna element pattern in metal trace bonded to an insulating dielectric substrate, such as a printed circuit board, with a continuous metal layer bonded to the opposite side of the substrate which forms a ground plane. Common microstrip antenna shapes are square ...
A Pringles cantenna for Wi-Fi. The cylinder portion of the can may consist of metal-coated paperboard.. Although some designs are based on a Pringles potato chips can, this tube is too narrow to increase the 2.4 GHz signal by a useful amount, [1] although at 5 GHz it would be about the right size.