Search results
Results from the WOW.Com Content Network
The transmission control unit (TCU) in older automobiles with a clutchless manual transmission (without a clutch pedal) typically consists of an electrical switch connected to the gearshift, that is activated whenever the internal transmission control unit senses driver touching the gearshift to switch gears, which then primes a sensor or ...
Often the ladder logic program is used in conjunction with a human–machine interface (HMI) program operating on a computer workstation. The motivation for representing sequential control logic in a ladder diagram was to allow factory engineers and technicians to develop software without additional training to learn a language such as FORTRAN ...
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
Mechatronics engineering, also called mechatronics, is an interdisciplinary branch of engineering that focuses on the integration of mechanical engineering, electrical engineering, electronic engineering and software engineering, [1] and also includes a combination of robotics, computer science, telecommunications, systems, control, automation and product engineering.
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
A PLC is an industrial microprocessor-based controller with programmable memory used to store program instructions and various functions. [21] It consists of: A processor unit (CPU) which interprets inputs, executes the control program stored in memory and sends output signals, A power supply unit which converts AC voltage to DC,
However, these methods require manual fabrication of devices, post processing/assembly, and lengthy iterations until maturity in the fabrication is achieved. To avoid the tedious and time-consuming aspects of the current fabrication processes, researchers are exploring an appropriate manufacturing approach for effective fabrication of soft ...
A robot with remote control programming has a preexisting set of commands that it will only perform if and when it receives a signal from a control source, typically a human being with remote control. It is perhaps more appropriate to view devices controlled primarily by human commands as falling in the discipline of automation rather than ...