Search results
Results from the WOW.Com Content Network
dBm or dB mW (decibel-milliwatts) is a unit of power level expressed using a logarithmic decibel (dB) scale respective to one milliwatt (mW). It is commonly used by radio, microwave and fiber-optical communication technicians & engineers to measure the power of system transmissions on a log scale , which can express both very large and very ...
A ratio higher than 1:1 (greater than 0 dB) indicates more signal than noise. SNR is an important parameter that affects the performance and quality of systems that process or transmit signals, such as communication systems, audio systems, radar systems, imaging systems, and data acquisition systems. A high SNR means that the signal is clear ...
High-powered transmissions, such as those used in broadcasting, are expressed in dB-millivolts per metre (dBmV/m). For very low-power systems, such as mobile phones , signal strength is usually expressed in dB - microvolts per metre (dBμV/m) or in decibels above a reference level of one milliwatt ( dBm ).
Comparison test can mean: Limit comparison test , a method of testing for the convergence of an infinite series. Direct comparison test , a way of deducing the convergence or divergence of an infinite series or an improper integral.
In mathematics, the comparison test, sometimes called the direct comparison test to distinguish it from similar related tests (especially the limit comparison test), provides a way of deducing whether an infinite series or an improper integral converges or diverges by comparing the series or integral to one whose convergence properties are known.
This can either be with a specific resolution bandwidth (e.g. −120 dBm @1 kHz RBW), or normalized to 1 Hz (usually in dBm/Hz) e.g. −150 dBm(Hz).This is also called the sensitivity of the spectrum analyzer. If a signal level equal to the average noise level is fed there will be a 3 dB display.
The dBm is an absolute reference level measurement (see Decibel § Suffixes and reference values) with respect to 1 mW power. When the nominal signal power is 0 dBm at the TLP, the test point is called a zero transmission level point, or zero-dBm TLP. The abbreviation dBm0 stands for the power in dBm measured
The noise figure is the difference in decibel (dB) between the noise output of the actual receiver to the noise output of an "ideal" receiver with the same overall gain and bandwidth when the receivers are connected to matched sources at the standard noise temperature T 0 (usually 290 K).