Search results
Results from the WOW.Com Content Network
Epoxy moisture control systems can be applied over concrete with relative humidity levels up to 100%, and there are systems available on the market today that can be applied over concrete that is physically damp. In some cases, with the use of an epoxy moisture control system, floor coverings can be installed just 7 days after the slab is poured.
The flow table test or slump-flow test is a method to determine consistency of fresh concrete. Flow table test is also used to identify transportable moisture limit of solid bulk cargoes. [ 1 ] It is used primarily for assessing concrete that is too fluid (workable) to be measured using the slump test , because the concrete will not retain its ...
Concrete sealers are applied to concrete to protect it from surface damage, corrosion, and staining. They either block the pores in the concrete to reduce absorption of water and salts or form an impermeable layer which prevents such materials from passing.
Depending on the FBE coating system, full cure can be achieved in less than one minute to few minutes in case of long cure FBE's, which are used for internal pipe coating applications. Rebars are coated in a similar manner as coating application, on the exterior of pipes. For FBE coating application on the interior of pipe surface, a lance is used.
A w/c ratio higher than 0.60 is not acceptable as fresh concrete becomes "soup" [2] and leads to a higher porosity and to very poor quality hardened concrete as publicly stated by Prof. Gustave Magnel (1889-1955, Ghent University, Belgium) during an official address to American building contractors at the occasion of one of his visits in the ...
A pressure washer is used to remove old paint from a boat. Patio flagstones being pressure washed using a rotary nozzle. Pressure washing or power washing is the use of high-pressure water spray to remove loose paint, mold, grime, dust, mud, and dirt from surfaces and objects such as buildings, vehicles and concrete surfaces.
This is linked to the maximum throughput discussed below. [5]: 302–303 Guidance on the design of rapid sand bed filters suggests that they should be operated with a maximum flow rate of 9 m 3 /m 2 /hr (220 US gal/ft 2 /hr). [7] Using the required throughput and the maximum flow rate, the required area of the bed can be calculated.
The minimum-cost flow problem (MCFP) is an optimization and decision problem to find the cheapest possible way of sending a certain amount of flow through a flow network.A typical application of this problem involves finding the best delivery route from a factory to a warehouse where the road network has some capacity and cost associated.