Search results
Results from the WOW.Com Content Network
Maintenance testing is a test that is performed to either identify equipment problems, diagnose equipment problems, or confirm that repair measures have been effective. It can be performed at either the system level (e.g., the HVAC system), the equipment level (e.g., the blower in an HVAC line), or the component level (e.g., a control chip in the control box for the blower in the HVAC line).
Organizational, or O-level maintenance occurs at the organizational unit level, for example by a single maintenance squadron as part of an aircraft wing. O-level maintenance is typically optimized for quick turn-around, to enhance operational availability.
Methods-Time Measurement (MTM) is a predetermined motion time system that is used primarily in industrial settings to analyze the methods used to perform any manual operation or task and, as a product of that analysis, to set the standard time in which a worker should complete that task.
In heating, ventilation, and air conditioning (HVAC), testing, adjusting and balancing (TAB) are the three major steps used to achieve proper operation of heating, ventilation, and air conditioning systems. TAB usually refers to commercial building construction and the specialized contractors who employ personnel that perform this service.
Lot quality assurance sampling (LQAS) is a random sampling methodology, originally developed in the 1920s [1] as a method of quality control in industrial production. Compared to similar sampling techniques like stratified and cluster sampling, LQAS provides less information but often requires substantially smaller sample sizes.
Quality control separates the act of testing products to uncover defects from the decision to allow or deny product release, which may be determined by fiscal constraints. [6] For contract work, particularly work awarded by government agencies, quality control issues are among the top reasons for not renewing a contract. [7]
Verification is intended to check that a product, service, or system meets a set of design specifications. [6] [7] In the development phase, verification procedures involve performing special tests to model or simulate a portion, or the entirety, of a product, service, or system, then performing a review or analysis of the modeling results.
Test coverage in the test plan states what requirements will be verified during what stages of the product life. Test coverage is derived from design specifications and other requirements, such as safety standards or regulatory codes, where each requirement or specification of the design ideally will have one or more corresponding means of verification.