enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Junction box - Wikipedia

   en.wikipedia.org/wiki/Junction_box

   A small metal or plastic junction box may form part of an electrical conduit or thermoplastic-sheathed cable (TPS) wiring system in a building. If designed for surface mounting, it is used mostly in ceilings, under floors or concealed behind an access panel—particularly in domestic or commercial buildings.

3. Electrical conduit - Wikipedia

   en.wikipedia.org/wiki/Electrical_conduit

   Box connectors join conduit to a junction box or other electrical box. A typical box connector is inserted into a knockout in a junction box, with the threaded end then being secured with a ring (called a lock nut ) from within the box, as a bolt would be secured by a nut.

4. Knob-and-tube wiring - Wikipedia

   en.wikipedia.org/wiki/Knob-and-tube_wiring

   Earthing systems. v. t. e. Knob-and-tube wiring (sometimes abbreviated K&T) is an early standardized method of electrical wiring in buildings, in common use in North America from about 1880 to the 1930s. [1][2] It consisted of single-insulated copper conductors run within wall or ceiling cavities, passing through joist and stud drill-holes via ...

5. NEMA enclosure types - Wikipedia

   en.wikipedia.org/wiki/NEMA_enclosure_types

   Below is a list of NEMA enclosure types; these types are further defined in NEMA 250- Enclosures for Electrical Equipment. Each type specifies characteristics of an enclosure, but not, for example, a specific enclosure size. Note that higher numbers do not include the lower-numbered tests. For example, types 3, 4 and 6 are intended for outdoor ...

6. Distribution board - Wikipedia

   en.wikipedia.org/wiki/Distribution_board

   A distribution board (also known as panelboard, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure. Normally, a main switch, and in recent ...

7. Electrical equipment in hazardous areas - Wikipedia

   en.wikipedia.org/wiki/Electrical_equipment_in...

   In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...