enow.com Web Search

  1. Ads

    related to: bottom entry float valve screwfix

Search results

  1. Results from the WOW.Com Content Network
  2. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    Air admittance valves (AAVs, or commonly referred to in the UK as Durgo valves and in the US as Studor vents and Sure-Vent®) are negative-pressure-activated, one-way mechanical valves, used in a plumbing or drainage venting system to eliminate the need for conventional pipe venting and roof penetrations.

  3. Float chamber - Wikipedia

    en.wikipedia.org/wiki/Float_chamber

    The valve is often described as a needle valve, although this is a misnomer. A true needle valve uses a tapered needle in a tapered seat, so as to provide fine control over flow rate. The float valve uses a pointed needle against a square-edged seat, to give a positive shut-off. As the float relies on gravity, the chamber must be mounted ...

  4. Ballcock - Wikipedia

    en.wikipedia.org/wiki/Ballcock

    A later innovation, the floatless fill valve, designed for low-profile, low-flow toilet tanks, uses a pressure-sensing diaphragm mechanism instead of a float to control the inlet valve. [4] Delay valves, which delay the filling until the level has dropped to a low level, avert short-cycling of the water supply.

  5. Float switch - Wikipedia

    en.wikipedia.org/wiki/Float_switch

    A float switch is a type of level sensor, a device used to detect the level of liquid within a tank. The switch may be used to control a pump, as an indicator, an alarm, or to control other devices. One type of float switch uses a mercury switch inside a hinged float. Another common type is a float that raises a rod to actuate a microswitch.

  6. Ball valve - Wikipedia

    en.wikipedia.org/wiki/Ball_valve

    A trunnion ball valve has additional mechanical anchoring of the ball at the top and the bottom, suitable for larger and higher pressure valves (generally above 3.9 in (10 cm) and 580 psi (40 bar)). A floating ball valve is one where the ball is not held in place by a trunnion.

  7. Automatic bleeding valve - Wikipedia

    en.wikipedia.org/wiki/Automatic_bleeding_valve

    The top has a small outlet, usually hidden beneath a plastic dust cap. Internally there is a large hollow body, normally filled with water, and containing a float valve. The valve must always be installed vertically, usually at the top of a short vertical pipe. If the valve body is filled with water, the float moves upwards and closes the valve.

  1. Ads

    related to: bottom entry float valve screwfix