Search results
Results from the WOW.Com Content Network
A sensor node, also known as a mote (chiefly in North America), is a node in a sensor network that is capable of performing some processing [1], gathering sensory information and communicating with other connected nodes in the network. A mote is a node but a node is not always a mote.
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
A wireless identification and sensing platform (WISP) is an RFID (radio-frequency identification) device that supports sensing and computing: a microcontroller powered by radio-frequency energy. [1] That is, like a passive RFID tag, WISP is powered and read by a standard off-the-shelf RFID reader, harvesting the power it uses from the reader's ...
There is also a threading tool, named Protothreads. Protothreads are described as "extremely lightweight stackless threads designed for severely memory constrained systems, such as small embedded systems or wireless sensor network nodes. [82] There is a port of FreeRTOS for the Arduino. [83] This is available from the Arduino Library Manager.
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
Wireless mesh architecture is a first step towards providing cost effective and low mobility over a specific coverage area. Wireless mesh infrastructure is, in effect, a network of routers minus the cabling between nodes.
NodeMCU DEVKIT 1.0, bottom. NodeMCU is a low-cost open source IoT platform. [4] [5] It initially included firmware which runs on the ESP8266 Wi-Fi SoC from Espressif Systems, and hardware which was based on the ESP-12 module. [6] [7] Later, support for the ESP32 32-bit MCU was added.
However, to facilitate migration from wired to wireless, WUSB introduced a new Device Wire Adapter (DWA) class. Sometimes referred to as a "WUSB hub", a DWA allows existing USB 2.0 devices to be used wirelessly with a WUSB host. WUSB host capability can be added to existing PCs through the use of a Host Wire Adapter (HWA). The HWA is a USB 2.0 ...