Search results
Results from the WOW.Com Content Network
Device configuration overlay (DCO) is a hidden area on many of today's hard disk drives (HDDs). Usually when information is stored in either the DCO or host protected area (HPA), it is not accessible by the BIOS (or UEFI), OS, or the user. However, certain tools can be used to modify the HPA or DCO.
Some vendor-specific external drive enclosures (e.g. Maxtor, owned by Seagate since 2006) are known to use HPA to limit the capacity of unknown replacement hard drives installed into the enclosure. When this occurs, the drive may appear to be limited in size (e.g. 128 GB), which can look like a BIOS or dynamic drive overlay (DDO) problem.
MS-DOS/PC DOS versions 4.0 and earlier assign letters to all of the floppy drives before considering hard drives, so a system with four floppy drives would call the first hard drive E:. Starting with DOS 5.0, the system ensures that drive C: is always a hard disk, even if the system has more than two physical floppy drives.
Several Parallel ATA hard disk drives. Parallel ATA, originally IDE and then standardized under the name AT Attachment (ATA), with the alias P-ATA or PATA retroactively added upon introduction of the new variant Serial ATA. The original name (circa 1986) reflected the integration of the controller with the hard drive itself.
Windows Mobile supports accessing most USB mass-storage devices formatted with FAT on devices with USB Host. However, portable devices typically cannot provide enough power for hard-drive disk enclosures (a 2.5-inch (64 mm) hard drive typically requires the maximum 2.5 W in the USB specification) without a self-powered USB hub. A Windows Mobile ...
Windows To Go is a feature in Windows 8 Enterprise, Windows 8.1 Enterprise, Windows 10 Education Windows 10 Enterprise and Windows 11 versions prior to the May 2020 update, that allows the system to boot and run from certain USB mass storage devices such as USB flash drives and external hard disk drives which have been certified by Microsoft as ...
To set up a live USB system for commodity PC hardware, the following steps must be taken: A USB flash drive needs to be connected to the system, and be detected by it; One or more partitions may need to be created on the USB flash drive; The "bootable" flag must be set on the primary partition on the USB flash drive
Within a standard hard drive form factor case the encryptor (BC), key store and a smaller form factor, commercially available, hard disk drive is enclosed. The enclosed hard disk drive's case can be tamper-evident, so when inspected the user can be assured that the data has not been compromised. The encryptors electronics including the key ...