Ads
related to: how to turn a sailboat light on 2 pole wire size 8
Search results
Results from the WOW.Com Content Network
The spinnaker pole is rigged to run from the base of the mast, [1] where there is a special fitting for attaching one end of the pole, out to windward over the side of the boat. There, one of the control lines of whichever sail it is to be used with is run through a fitting on the other end of the spinnaker pole. This allows for more precise ...
When the boat jibes, the spinnaker pole will be moved from one side of the boat to the other, causing the sheet to become the guy and vice versa. A foreguy may also be used to control the height of the spinnaker pole. It is attached either to the end of the pole or to a bridle on the bottom of the pole, and runs through a padeye on the foredeck ...
Watercraft navigation lights must permit other vessels to determine the type and relative angle of a vessel, and thus decide if there is a danger of collision. In general, sailing vessels are required to carry a green light that shines from dead ahead to 2 points (22 + 1 ⁄ 2 °) abaft [note 1] the beam on the starboard side (the right side from the perspective of someone on board facing ...
Guy (red arrow), controlling the spinnaker pole. The guys supporting a sailboat mast are called "standing rigging" and in modern boats are stainless steel wire rope. Guys are rigged to the bow and stern, usually as a single guy. Lateral guys attach to "chain plates" port and starboard attached to the hull.
"To stay" is also a verb: to bring the ship's head up to the wind (to point the bow upwind). [2] This is done in order to go about (to tack ; tacking is sometimes also called staying the vessel [ 3 ] ); the bow of the ship turns upwind, then continues turning until the wind comes over the other side.
In sailing, a boom is a spar (pole), along the foot of a fore and aft rigged sail, that greatly improves control of the angle and shape of the sail. The primary action of the boom is to keep the foot flatter when the sail angle is away from the centerline of the boat. The boom also serves as an attachment point for more sophisticated control lines.
The rule is "worm and parcel with the lay; turn and serve the other way". When parcelling is used on modern small craft, friction tape or cotton athletic tape can be used for the purpose. On rare occasions, when parcelling is not to be served (e.g., for short term use to protect a line against chafe), it should be applied against the lay of the ...
[2] Spinnaker – Some sailboats use a symmetrical spinnaker—a three-sided, parachute-like sail—off the wind. The windward lower corner of a spinnaker is attached to a horizontal pole, coming from the mast to the lower corner of the sail—controlled by a line, called a guy—and the other lower corner is attached to a line that acts as a ...
Ads
related to: how to turn a sailboat light on 2 pole wire size 8