Search results
Results from the WOW.Com Content Network
The steel square is a tool used in carpentry. Carpenters use various tools to lay out structures that are square (that is, built at accurately measured right angles), many of which are made of steel, but the name steel square refers to a specific long-armed square that has additional uses for measurement, especially of various angles. It ...
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
Framing square, or steel square, or carpenter's square, or roofing square Originally designed for timber framing, a framing square is made from a single flat piece of metal or polymer to a standardised design with a long, wide blade and at 90° to that a shorter, narrower tongue. It can also be used for measuring lengths and for calculating angles.
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
The jambs of a window outside the frame are called reveals. Small shafts to doors and windows with caps and bases are called jamb-shafts; when in the inside arris of the jamb of a window, they are sometimes called scoinsons. [2] A doorjamb, door jamb, or sometimes doorpost is the vertical portion of the door frame onto which a door is secured. [3]
T-slot framing is divided into metric and fractional (imperial) categories. The T-slot is always centered along the long-axis of the piece. Pieces are available in each series with a square cross-section. Rectangular cross sections are also available which measure x by 2x (where x is the defined width) - e.g. 40mm by 80mm for 40 series.
The Speed Square is manufactured from a variety of materials such as aluminum, steel, and composites such as HDPE. They are also made in several sizes such as 4, 6, 7, 8 and 12 inch, and 25 cm. Embedded degree gradations on the tool eliminate the need for trigonometric calculations and allow for lines to be more easily made.
The girt system must be competent and adequately stiff to provide the required stabilizing resistance in addition to its role as a wall panel support. [citation needed] Girts are stabilized by (sag) rods/angles/straps and by the wall cladding. Stabilizing rods are discrete brace members to prevent rotation of an unsupported flange of the girt.