Search results
Results from the WOW.Com Content Network
Fluorescent bulbs contain mercury, a toxic substance. The United States Environmental Protection Agency (EPA) provides safety guidelines for how to clean up a broken fluorescent bulb. [17] Mercury can be harmful to children and developing fetuses, so children and pregnant women should avoid being in the area whilst a broken bulb is cleaned up. [18]
Fluorescent lamps with magnetic ballasts flicker at a normally unnoticeable frequency of 100 or 120 Hz and this flickering can cause problems for some individuals with light sensitivity; [69] they are listed as problematic for some individuals with autism, epilepsy, [70] lupus, [71] chronic fatigue syndrome, Lyme disease, [72] and vertigo.
In visual perception, flicker is a human-visible change in luminance of an illuminated surface or light source which can be due to fluctuations of the light source itself, or due to external causes such as due to rapid fluctuations in the voltage of the power supply (power-line flicker) or incompatibility with an external dimmer.
However, a faulty fluorescent lamp can flicker at a much lower rate and trigger seizures. [medical citation needed] Newer high-efficiency compact fluorescent lamps (CFL) with electronic ballast circuits operate at much higher frequencies (10–20 kHz) not normally perceivable by the human eye, though defective lights can still cause problems.
A flicker light bulb, flicker flame light bulb or flicker glow lamp is a gas-discharge lamp which produces light by ionizing a gas, usually neon mixed with helium and a small amount of nitrogen gas, by an electric current passing through two flame shaped electrode screens coated with partially decomposed barium azide. The ionized gas moves ...
Flicker noise is a type of electronic noise with a 1/f power spectral density. It is therefore often referred to as 1/ f noise or pink noise , though these terms have wider definitions. It occurs in almost all electronic devices and can show up with a variety of other effects, such as impurities in a conductive channel, generation and ...
Cross section of a typical fluorescent lamp with and without a reflector. Some lamps have an internal opaque reflector. Coverage of the reflector ranges from 120° to 310° of the lamp's circumference. Reflector lamps are used when light is only desired to be emitted in a single direction, or when an application requires the maximum amount of ...
Circular and U-shaped lamps were devised to reduce the length of fluorescent light fixtures. The first fluorescent light bulb and fixture were displayed to the general public at the 1939 New York World's Fair. The spiral CFL was invented in 1976 by Edward E. Hammer, an engineer with General Electric, [7] in response to the 1973 oil crisis. [8]