Search results
Results from the WOW.Com Content Network
Apple Lightning to USB-A cable. Lightning is an 8-pin digital connector. Unlike the 30-pin dock connector it replaced (and USB Type-A and -B connectors), it is reversible. [24] Most Lightning devices only support USB 2.0, which has a maximum transfer speed of 480 Mbit/s or 60 MB/s. With USB 2.0, only one lane is in use at a time.
The Universal Serial Bus Micro-USB Cables and Connectors Specification details the mechanical characteristics of Micro-A plugs, Micro-AB receptacles (which accept both Micro-A and Micro-B plugs), and Micro-B plugs and receptacles, [20] along with a permitted adapter with a Standard-A receptacle and a Micro-A plug, as would be used e.g. to ...
USB connectors have been increasingly replacing other types of charging cables for portable devices. USB connector interfaces are classified into three types: the many various legacy Type-A (upstream) and Type-B (downstream) connectors found on hosts, hubs, and peripheral devices, and the modern Type-C connector, which replaces the many legacy ...
An OTG cable has a micro-A plug on one end, and a micro-B plug on the other end (it cannot have two plugs of the same type). OTG adds a fifth pin to the standard USB connector, called the ID-pin; the micro-A plug has the ID pin grounded, while the ID in the micro-B plug is floating.
Thunderbolt 3, 4, or 5 ports USB-C Thunderbolt 3, 4, or 5 connector. Thunderbolt 3 is a hardware interface developed by Intel. [75] It shares USB-C connectors with USB, supports USB 3.1 Gen 2, [76] [77] [78] and can require special "active" cables for maximum performance for cable lengths over 0.5 meters (1.5 feet). Compared to Thunderbolt 2 ...
USB-C plug USB-C (SuperSpeed USB 5Gbps) receptacle on an MSI laptop. USB-C, or USB Type-C, is a 24-pin, reversible connector (not a protocol) that supersedes previous USB connectors and can carry audio, video, and other data, to connect to monitors, external drives, hubs/docking stations, mobile phones, and many more peripheral devices.
Schematic symbols for male and female connector pins. In electrical and mechanical trades and manufacturing, each half of a pair of mating connectors or fasteners is conventionally designated as male or female, [1] a distinction referred to as its gender. [2] The female connector is generally a receptacle that receives and holds the male connector.
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.