enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Alternate wetting and drying - Wikipedia

   en.wikipedia.org/wiki/Alternate_wetting_and_drying

   A water tube/pipe made of PVC is usually used to practice AWD method. The main purpose of the tube is to monitor the water depth. The tube allows measuring water availability in the field below the soil surface. The usual practice is to use a pipe of 7–10 cm diameter and 30 cm long, with perforations in bottom 20 cm.

3. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   For instance, 1/2" PeX tubing is the same size as 1/2" copper tubing. 1/2" PVC on the other hand is not the same size as 1/2" tubing, and therefore requires either a threaded male or female adapter to connect them. When used in agricultural irrigation, the singular form "pipe" is often used as a plural. [27]

4. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   For pipe sizes less than NPS 14 inch (DN 350), both methods give a nominal value for the OD that is rounded off and is not the same as the actual OD. For example, NPS 2 inch and DN 50 are the same pipe, but the actual OD is 2.375 inches or 60.33 millimetres. The only way to obtain the actual OD is to look it up in a reference table.

5. Plastic pipework - Wikipedia

   en.wikipedia.org/wiki/Plastic_pipework

   Plastic Pipe lengths manufactured in Australia by extruding HDPE material.. Plastic pipe is a tubular section, or hollow cylinder, made of plastic.It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow—liquids and gases (fluids), slurries, powders and masses of small solids.

6. JM Eagle - Wikipedia

   en.wikipedia.org/wiki/JM_Eagle

   JM Eagle is an American corporation and a manufacturer of plastic pipe. [1] At its 22 plants in North America, the company manufactures polyvinyl chloride (PVC) and high-density polyethylene pipe for a variety of industries including utility, plumbing, electrical, natural gas, irrigation, potable water, drainage, and sewage.

7. Drip irrigation - Wikipedia

   en.wikipedia.org/wiki/Drip_irrigation

   Pulsed systems are typically expensive and require extensive maintenance. Therefore, the latest efforts by emitter manufacturers are focused on developing new technologies that deliver irrigation water at ultra-low flow rates, i.e. less than 1.0 L (2.1 US pints; 1.8 imperial pints) per hour.