enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Trailer connectors in North America - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   7-pin blade connector (Towing vehicle side) This is common for RVs and other large trailers which have additional loads beyond the basic for tail lights and brake/turn signals. The standard is defined by SAE J2863, Automotive Trailer Tow Connector. #

3. ISO standards for trailer connectors - Wikipedia

   en.wikipedia.org/wiki/ISO_standards_for_trailer...

   7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.

4. Trailer connector - Wikipedia

   en.wikipedia.org/wiki/Trailer_Connector

   A trailer connector is a multi-pole electrical connector between a towing vehicle (car, truck) and a trailer. It is intended primarily to supply automotive lighting on the trailer, but also provide management and supply to other loads. It is also referred to as "trailer wire," "trailer cable," or "trailer connecting cable."

5. Trailer connectors in Australia - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   Round 7-pin trailer connector Type 1, Australian Standard 2513. In this pinout for an ISO 1724 connector, the position light pin is used for electric brakes (Pin 5, 58R), which means that if you connect a trailer with electric brakes to a towing vehicle wired according to ISO 1724 and turn on the position lights the trailer will be braking. Pin ...

6. Trailer connectors in military organizations - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   Trailer connector according to NATO STANAG 4007. NATO uses a 12-pin connector [NATO 1] [NATO 2] according to STANAG 4007. [1] However, note that there are often deviations from the standard depending on which country it is applied, which means that the table below may not be accurate.

7. SAE J1772 - Wikipedia

   en.wikipedia.org/wiki/SAE_J1772

   SAE J1772, also known as a J plug or Type 1 connector after its international standard, IEC 62196 Type 1, is a North American standard for electrical connectors for electric vehicles maintained by SAE International under the formal title "SAE Surface Vehicle Recommended Practice J1772, SAE Electric Vehicle Conductive Charge Coupler".