Search results
Results from the WOW.Com Content Network
In North American, but most commonly the USA market, it is very common for brake lights and turn signals to be combined. On cars and light trucks (listed below as Light Vehicles) there is no formal standard, instead there is an accepted standard. However, you can not be entirely sure until you have meas
1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45) A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35. Connectors on this cable would be designated:
A Digital transport/terminal adapter (or DTA) is a device used by cable companies who are switching to all-digital cable systems. They typically have an RF input for receiving service, and a modulated output on Channel 3 or 4 that allows a TV to be set to channel 3 or 4 and have the tuner change channels.
Pace Micro Technology DC757X HD cable box. A cable converter box or television converter box is an electronic tuning device that transposes/converts channels from a cable television service to an analog RF signal on a single channel, usually VHF channel 3 or 4, or to a different output for digital televisions such as HDMI.
A digital television adapter (DTA), commonly known as a converter box or decoder box, is a television tuner that receives a digital television (DTV) transmission, and converts the digital signal into an analog signal that can be received and displayed on an analog television set.
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).
The stuffing box prevents water from entering the boat's hull. In many small fiberglass boats, for example, the stuffing box is mounted inboard near the point the shaft exits the hull. The "box" is a cylindrical assembly, typically of bronze, comprising a sleeve threaded on one end to accept adjusting and locking nuts.
The Bede BD-1 was a two-seat, single-engine, low-wing monoplane, the first design of American aeronautical engineer Jim Bede.The BD-1 was designed in 1960 as a kit-built aircraft intended for home assembly by amateur builders. [2]