Search results
Results from the WOW.Com Content Network
The Interrupt flag (IF) is a flag bit in the CPU's FLAGS register, which determines whether or not the (CPU) will respond immediately to maskable hardware interrupts. [1] If the flag is set to 1 maskable interrupts are enabled. If reset (set to 0) such interrupts will be disabled until
FLAGS registers can be moved from or to the stack. This is part of the job of saving and restoring CPU context, against a routine such as an interrupt service routine whose changes to registers should not be seen by the calling code. Here are the relevant instructions: The PUSHF and POPF instructions transfer the 16-bit FLAGS register.
Clock-comparator subclass mask 0 21 CPU-timer subclass mask 0 22 Service-signal subclass mask 0 24 Set to 1 0 25 Interrupt-key subclass mask 0 26 Set to 1 0 27 ETR subclass mask 0 28 Program-call-fast 0 29 Crypto control 1 0 Primary space-switch-event control 1 1-19 Primary segment-table origin 1 22 Primary subspace-group control 1 23
1. Open the Windows Control Panel. 2. Click Programs. 3. Click DataMask by AOL. 4. Click Change/Remove, Add/Remove, or Uninstall. - If there is no entry in the Add/Remove Programs window for DataMask by AOL, contact our technical support team at datamaskhelp@aol.com. 5. Follow the on screen prompts. 6. Restart your computer to complete the ...
The most significant byte (MSB) of the program counter (PC) is pushed onto the stack. The least significant byte (LSB) of the program counter is pushed onto the stack. The status register (SR) is pushed onto the stack. The interrupt disable flag is set in the status register. 65C816/65C802: PB is loaded with $00.
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
The interrupt controller sends an interrupt request (or IRQ) to the CPU with a certain priority level, and the CPU sets a mask that causes any other interrupts with a lower priority to be put into a pending state, until the CPU releases control back to the interrupt controller. If a signal comes in at a higher priority, then the current ...
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...