Search results
Results from the WOW.Com Content Network
To take a common example, 195/55R16 would mean that the nominal width of the tire is approximately 195 mm at the widest point, the height of the side-wall of the tire is 55% of the width (107 mm in this example) and that the tire fits 16-inch-diameter (410 mm) rims. The code gives a direct calculation of the theoretical diameter of the tire.
A snow dump site is a location where snow is dumped as a part of the snow removal process. Designated sites are sometimes required to prevent water and ground pollution because the snow collected on roads typically contain a variety of grit, de-icing chemicals, vehicle fluids, engine emissions, and litter.
In many applications tapered roller bearings are used in back-to-back pairs so that axial forces can be supported equally in either direction. Pairs of tapered roller bearings are used in car and vehicle wheel bearings where they must cope simultaneously with large vertical (radial) and horizontal (axial) forces.
Snow chains should be installed on one or more drive axles of the vehicle, with requirements varying for dual-tire or multi-driven-axle vehicles that range from "one pair of tires on a driven axle" to "all tires on all driven axles", possibly also one or both steering (front) wheels, requiring snow chains whenever required by signage or conditions.
For a bearing where average of outer diameter of bearing and diameter of axle hole is 50 mm, and that is rotating at 3000 RPM, recommended dynamic viscosity is 12 mm 2 /s. [7] Note that dynamic viscosity of oil varies strongly with temperature: a temperature increase of 50–70 °C causes the viscosity to decrease by factor 10. [7]
Wheels with Asanti 28 in (710 mm) rims on a police Hummer H2 car. The wheel size is the size designation of a wheel given by its diameter, width, and offset. The diameter of the wheel is the diameter of the cylindrical surface on which the tire bead rides. The width is the inside distance between the bead seat faces.
The bearing surface describes the contact area between two objects used as datum. It is often the underside of a screw head (male seat, marked A) or a flat at the end of the screw thread (female seat, marked B). A bearing surface in mechanical engineering is the area of contact between two objects.
Although bearings tend to wear out with use, designers can make tradeoffs of bearing size and cost versus lifetime. A bearing can last indefinitely—longer than the rest of the machine—if it is kept cool, clean, lubricated, is run within the rated load, and if the bearing materials are sufficiently free of microscopic defects.