Search results
Results from the WOW.Com Content Network
6V6 Octal socket basing diagram. 1 - * Unconnected in all versions except for the shell connection of the metal 6V6 2 & 7 - Filament / Heater 3 - Anode / Plate 4 - Grid 2 / Screen Grid 5 - Grid 1 / Control Grid 6 - No connection. Pin normally absent 8 - Cathode & Beam-Forming Plates. The 6V6 is a beam-power tetrode vacuum tube.
The B7G (or "small-button" or "heptal") seven-pin miniature tubes are smaller than Noval, with seven pins arranged at 45-degree spacing in a 9.53 mm (3/8th inch) diameter arc, the "missing" pin position being used to position the tube in its socket (unlike octal, loctal and rimlock sockets). Examples include the 6AQ5/EL90 and 6BE6/EK90.
The transmitting tubes TT21 and TT22 have almost identical transfer characteristics to KT88 but a different pinout, and by virtue of their anode being connected to the top cap have a higher plate voltage rating (1.25 kilovolt) and a higher power output capability of 200 watts in class AB1 push–pull.
The Г-807 (G-807) is a Soviet/Russian version. The 6П7С (6P7S) is similar to Г-807, but with an 8-pin octal base. The 807 also found some use as a horizontal output tube in early TV receivers, particularly those manufactured by DuMont.
Same Characteristics as 1B3GT. Many listed and labeled as 1B3GT/1G3GT. 1H2 – Noval High-voltage rectifier with 1.4 V/550 mA filament; 1J3GT – Octal High-voltage rectifier. Same Characteristics as 1B3GT. Has filament-plate shorting protection. Many listed and labeled as 1J3GT/1K3GT. 1K3GT – Octal High-voltage rectifier. Same ...
Special "octal" connectors with either 8 or 11 pins, almost identical to octal relay sockets or tube sockets, were used to connect power supplies to some tube audio amplifiers, transmitters, and transceivers (especially in amateur radio models). Female sockets were installed on the power supply and male sockets (with exposed pins) on the radio ...
Sets that use the costly WD-11 and UV-199 tubes can be modified to use the 1A5/GT octal power pentode (Which cost around $2.50) by wiring a 5.1 ohm resistor between the pins of the filament and fabricating an octal-to-four pin adaptor. The pin for the 1A5's suppressor is left unconnected and the screen connected to the plate.
An 1100/62 Model E1 (upgraded version) – Medium Performance Multiprocessor Complex – two CPUs with 2K Buffer Storage, two IOUs with one Block Mux, and one Word Channel module (four channels), 1048K words of Main Storage, two System Support Processors, two System Consoles, and a Maintenance Console listed for $889,340. in March 1980.