Search results
Results from the WOW.Com Content Network
The technique provides the user with useful suggestions as to how to reduce the occurrence of errors [4] It provides ready linkage between Ergonomics and Process Design, with reliability improvement measures being a direct conclusion which can be drawn from the assessment procedure.
An error-tolerant design (or human-error-tolerant design [1]) is one that does not unduly penalize user or human errors. It is the human equivalent of fault tolerant design that allows equipment to continue functioning in the presence of hardware faults, such as a "limp-in" mode for an automobile electronics unit that would be employed if ...
Thus, the importance of soft errors increases as chip technology advances. In a logic circuit, Q crit is defined as the minimum amount of induced charge required at a circuit node to cause a voltage pulse to propagate from that node to the output and be of sufficient duration and magnitude to be reliably latched.
In the event of an error, end-users remain unaware of any issues. Conversely, a system that experiences errors with some interruption in service or graceful degradation of performance is termed 'resilient'. In resilience, the system adapts to the error, maintaining service but acknowledging a certain impact on performance.
The on-line textbook: Information Theory, Inference, and Learning Algorithms, by David J.C. MacKay, contains chapters on elementary error-correcting codes; on the theoretical limits of error-correction; and on the latest state-of-the-art error-correcting codes, including low-density parity-check codes, turbo codes, and fountain codes.
In engineering, a fail-safe is a design feature or practice that, in the event of a failure of the design feature, inherently responds in a way that will cause minimal or no harm to other equipment, to the environment or to people.
Such errors are considered different than errors caused by different reasons; errors made during measurement reading, errors caused by human errors, and errors caused by a change in the measurement environment caused by the presence of the instrument affecting the environment.
In engineering, a fault is a defect or problem in a system that causes it to fail or act abnormally. The ISO document 10303-226 defines fault as an abnormal condition or defect at the component, equipment, or sub-system level which may lead to a failure. The United States Glossary of Telecommunication Terms defines fault for telecommunications as: