Search results
Results from the WOW.Com Content Network
The pressure and temperature of the gas are directly proportional: As temperature increases, the pressure of the propane gas increases by the same factor. A simple consequence of this proportionality is that on a hot summer day, the propane tank pressure will be elevated, and thus propane tanks must be rated to withstand such increases in pressure.
The van der Waals equation of state may be written as (+) =where is the absolute temperature, is the pressure, is the molar volume and is the universal gas constant.Note that = /, where is the volume, and = /, where is the number of moles, is the number of particles, and is the Avogadro constant.
Once the constants and are experimentally determined for a given substance, the van der Waals equation can be used to predict attributes like the boiling point at any given pressure, and the critical point (defined by pressure and temperature such that the substance cannot be liquefied either when > no matter how low the temperature, or when ...
For air, he found a relative expansion ΔV/V = 37.50% and obtained a value of α = 37.50%/100 °C = 1/266.66 °C which indicated that the value of absolute zero was approximately 266.66 °C below 0 °C. [12] The value of the rate of expansion α is approximately the same for all gases and this is also sometimes referred to as Gay-Lussac's Law.
When comparing the same substance under two different sets of conditions, the law can be expressed as: =. showing that as volume increases, the pressure of a gas decreases proportionally, and vice versa. Boyle's law is named after Robert Boyle, who published the original law in 1662. [3]
For a given mass of an ideal gas, the volume and amount (moles) of the gas are directly proportional if the temperature and pressure are constant. The law is named after Amedeo Avogadro who, in 1812, [ 2 ] [ 3 ] hypothesized that two given samples of an ideal gas, of the same volume and at the same temperature and pressure, contain the same ...
In the same conditions of temperature and pressure, the molar mass is proportional to the mass density. Therefore, the rates of diffusion of different gases are inversely proportional to the square roots of their mass densities: where: ρ is the mass density.
The main feature of thermodynamic diagrams is the equivalence between the area in the diagram and energy. When air changes pressure and temperature during a process and prescribes a closed curve within the diagram the area enclosed by this curve is proportional to the energy which has been gained or released by the air.