Search results
Results from the WOW.Com Content Network
This diagram shows the wiring of a British type G three pin plug. Externally it looks like this:en:Image:G plug.jpg: Date: 23 April 2011: Source: Traced from File:Three pin mains plug (UK).png: Author: Slashme: Other versions {Three pin mains plug (UK).png:
In 1885, two-pin plug designs appeared and in 1889 there were two-pin plugs and sockets in the GEC catalogue. [28] The 1893 GEC Catalogue included three sizes of what was described as Double plug Sockets with capacities described not in amps, but as "1 to 5 lights", "5 to 10 lights" and "10 to 20 lights".
The shank of the active and neutral pins of every 10 amp and 15 amp flat-pin plug sold after 3 April 2005 are required to be insulated, in accordance with AS/NZS 3112:2000. [ 1 ] Since 2000, the nominal voltage in most areas of Australia has been 230 V, [ 2 ] [ 3 ] [ 4 ] except for Western Australia, which remains at 240 V, and Queensland ...
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
AC power plugs are also commonly circular, for example, Schuko plugs and IEC 60309. NMEA 2000 cabling using M12 connectors The M12 connector , specified in IEC 61076-2-101, is a circular electrical plug/receptacle pair with 12mm OD mating threads, used in NMEA 2000 , DeviceNet , IO-Link , some kinds of Industrial Ethernet , etc. [ 16 ] [ 17 ]
There are two types of sockets and plugs in NBR 14136: one for 10 A, with a 4.0 mm pin diameter, and another for 20 A, with a 4.8 mm pin diameter. [13] This differs from IEC 60906-1 which specifies a pin diameter of 4.5 mm and a rating of 16 A. NBR 14136 does not require shutters on the apertures, a further aspect of non-compliance with IEC ...
The term plug is in general and technical use in all forms of English, common alternatives being power plug, [1] electric plug, [2] and (in the UK) plug top. [3] The normal technical term (in both British and International English) for an AC power socket is socket-outlet , [ 4 ] but in non-technical common use a number of other terms are used.
For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...