Ad
related to: best friction polish for turning metal
Search results
Results from the WOW.Com Content Network
One takes great care to remove any surface defects in the metal, like pits, that could allow bacteria to grow. A #4 dairy or sanitary finish is produced by polishing with a 180–240 grit belt or wheel finish softened with 120–240 grit greaseless compound or a fine non woven abrasive belt or pad.
Turned, ground, and polished (TGP) is a classification of finishing processes often used for metal shafting. Turning (on a lathe) creates straight round bars without the strain induced by cold drawing, while grinding and polishing improves the surface finish and roundness for high dimensional accuracy. [1]
Polishing is the process of creating a smooth and shiny surface by rubbing it or by applying a chemical treatment, leaving a clean surface with a significant specular reflection (still limited by the index of refraction of the material according to the Fresnel equations). [1]
The removal of oxidization (tarnish) from metal objects is accomplished using a metal polish or tarnish remover; this is also called polishing. To prevent further unwanted oxidization, polished metal surfaces may be coated with wax, oil, or lacquer. This is of particular concern for copper alloy products such as brass and bronze. [2]
Hard turning is a type of turning done on materials with a Rockwell C hardness greater than 45. It is typically performed after the workpiece is heat treated. [3] The process is intended to replace or limit traditional grinding operations. Hard turning, when applied for purely stock removal purposes, competes favorably with rough grinding.
Metal tumbling is used to burnish, deburr, clean, radius, de-flash, descale, remove rust, polish, brighten, surface harden, prepare parts for further finishing, and break off die cast runners. [citation needed] The process is fairly simple: a horizontal barrel is filled with the parts which is then rotated. Variations of this process usually ...
Brasso has also been used to polish out scratches in plastics: It has been used to polish CDs, DVDs, screens, and pools to repair scratches. It is a mild solvent and an extremely fine abrasive, so when applied to the reflective surface of the disc and rubbed radially (in straight lines between the edge and centre), it can smooth scratches and reduce their effect.
The foreground shows the mandrel for the base. Behind the finished vase are the spinning tools used to shape the metal. Metal spinning, also known as spin forming or spinning or metal turning most commonly, is a metalworking process by which a disc or tube of metal is rotated at high speed and formed into an axially symmetric part. [1]
Ad
related to: best friction polish for turning metal