Search results
Results from the WOW.Com Content Network
A bent in American English is a transverse rigid frame (or similar structures such as three-hinged arches).Historically, bents were a common way of making a timber frame; they are still often used for such, and are also seen in small steel-frame buildings, where the term portal frame is more commonly used.
Menards sold the Menard Building Division in 1994, racking up 36 years in the pole building industry. Menards of East Madison, Wisconsin, pictured in 2012 (closed and relocated to Sun Prairie in 2018) [6] Menards was founded as Menard Cashway Lumber. In the mid-1980s, the "Cashway Lumber" name was dropped and the business became simply known to ...
The batter angle is typically described as a ratio of the offset and height or a degree angle that is dependent on the building materials and application. For example, typical dry-stone construction of retaining walls utilizes a 1:6 ratio, that is for every 1 inch that the wall steps back, it increases 6 inches in height.
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
A set square is used in technical drawing, providing a straightedge at a right angle or another particular planar angle to a baseline. They are commonly made from clear plastic. The most common set squares are 45° squares, (one 90° corner and two 45° corners) and 60/30 triangles (a 90°, a 60° and a 30° corner).
The shelf angle, in turn, is attached to major elements of the building structure such as floor beams or structural columns. Shelf angles are in reality a horizontal expansion joint which allows growth of the brick below the shelf angle and to allow movement or shrinkage of the frame without putting stresses on the brick veneer.
An angle bracket or angle brace or angle cleat is an L-shaped fastener used to join two parts generally at a 90-degree angle. It is typically made of metal but it can also be made of wood or plastic. Angle brackets feature holes in them for screws. A typical example use of is a shelf bracket for mounting a shelf on a wall.
Overhanging eaves forming shelter around the building are a consequence where the gable wall is in line with the other walls of the buildings; i.e., unless the upper gable is recessed. Saltbox, catslide: A gable roof with one side longer than the other, and thus closer to the ground unless the pitch on one side is altered.