Search results
Results from the WOW.Com Content Network
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
A ruler, marked in centimeters (top), and inches (bottom). The rising and falling pattern of vertical lines on the inch scale resembles the ruler function. In number theory , the ruler function of an integer n {\displaystyle n} can be either of two closely related functions.
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
A ruler with two linear scales: the metric and imperial.It includes shorter minor graduations and longer major graduations. A graduation is a marking used to indicate points on a visual scale, which can be present on a container, a measuring device, or the axes of a line plot, usually one of many along a line or curve, each in the form of short line segments perpendicular to the line or curve.
This can be confusing because it refers to two distinct measurements as if they were measured with the same unit. Normally one would think a 3 by 6 advertisement would be 3 inches wide by 6 inches high — but in reality it's actually about 5.5 inches wide by 6 inches high. In writing, an "×" is usually used to separate the two figures ...
Unit and value marks — as on a ruler or number line; Congruence notation in geometry — as on a geometric figure; Graphed points — as on a graph; Hatch marks are frequently used as an abbreviation of some common units of measurement. In regard to distance, a single hatch mark indicates feet, and two hatch marks indicate inches.
English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.