Search results
Results from the WOW.Com Content Network
Hexagon slotted nuts and castle nuts with metric coarse and fine pitch thread – Product grades A and B: Active: DIN 935-2: M42 to M160x6 hexagon head nuts; product grade B: Active: DIN 935-3: Hexagon slotted nuts with metric coarse pitch thread – Product grade C: Active: DIN 936: M8 to M52 and M8x1 to M52x3 hexagon thin nuts; product grades ...
The cage has two wings that when compressed allow the cage to be inserted into the square holes Clip-on nut: J-nut or U-nut, sheet metal nut, speed nut (ambiguously) Designed to be clipped to sheet metal Coupling nut: Extension nut A threaded fastener for joining two male threads, most commonly a threaded rod,[1][2] but also pipes Flange nut ...
A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.
Holes are drilled in nuts and bolt heads, and wire is threaded through the holes to prevent back-rotation. This method of locking is labor intensive, but is still used on critical joints. [1] Locknuts Some portion of the nut deforms elastically during tightening to provide a locking action. Spring washers and lock washers
The simplest – and strongest – form of anchor bolt is cast-in-place, with its embedded end consisting of a standard hexagonal head bolt and washer, 90-bend, or some sort of forged or welded flange (see also stud welding). The last are used in concrete-steel composite structures as shear connectors. [6]
ISO 4162:2012 Hexagon bolts with flange — Small series — Product grade A with driving feature of product grade B; ISO 4164:2012 Mopeds — Engine test code — Net power; ISO 4165 Road vehicles — Electrical connections — Double-pole connection; ISO 4166:1979 Hexagon nuts for fine mechanics — Product grade F [Withdrawn without replacement]
They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole ...
The bearing surface describes the contact area between two objects used as datum. It is often the underside of a screw head (male seat, marked A) or a flat at the end of the screw thread (female seat, marked B). A bearing surface in mechanical engineering is the area of contact between two objects.