Search results
Results from the WOW.Com Content Network
For example, pharmaceuticals that pick up more than 5% by mass, between 40 and 90% relative humidity at 25 °C, are described as hygroscopic, while materials that pick up less than 1%, under the same conditions are regarded as non-hygroscopic. [32] The amount of moisture held by hygroscopic materials is usually proportional to the relative ...
Evaluate the quality and homogeneity of concrete materials; Predict the strength of concrete [7] [8] Evaluate dynamic modulus of elasticity of concrete, Estimate the depth of cracks in concrete. Detect internal flaws, cracks, honeycombing, and poor patches. The test can also be used to evaluate the effectiveness of crack repair. [9]
In the hygroscopic cycle, the gas absorbed-dissolved into the other fluid is the steam coming from the outlet of the steam turbine. As the steam is absorbed-dissolved into the hygroscopic fluid, more steam can condense, and the reduction in vapor pressure is equivalent to a reduction in the condensation pressure at the outlet of the steam turbine.
Materials such as stones, sand and ceramics are considered 'dry' and have much lower equilibrium moisture content than organic material like wood and leather. [7] typically a fraction of a percent by weight when in equilibrium of air of Relative humidity 10% to 90%. This affects the rate that buildings need to dry out after construction ...
In this technique, a sample of material is weighed, heated in an oven for an appropriate period, cooled in the dry atmosphere of a desiccator, and then reweighed. If the volatile content of the solid is primarily water, the loss on drying technique gives a good measure of moisture content. [ 5 ]
The relationship between water content and equilibrium relative humidity of a material can be displayed graphically by a curve, the so-called moisture sorption isotherm. For each humidity value, a sorption isotherm indicates the corresponding water content value at a given temperature. If the composition or quality of the material changes, then ...
Variables on the material points: positions, velocities, strains, stresses etc. are then updated with these rates depending on integration scheme of choice and a suitable constitutive model. Resetting of grid. Now that the material points are fully updated at the next time step, the grid is reset to allow for the next time step to begin.
Rising damp from the ground may be prevented by most simple means. Six inches of good Portland cement concrete should cover the whole site of the dwelling, and concrete never less than nine inches thick should underlie all walls. A damp course should disconnect the whole of the foundations from the superstructure.