Search results
Results from the WOW.Com Content Network
Making a saline water solution by dissolving table salt in water.The salt is the solute and the water the solvent. In chemistry, a solution is defined by IUPAC as "A liquid or solid phase containing more than one substance, when for convenience one (or more) substance, which is called the solvent, is treated differently from the other substances, which are called solutes.
Standard solutions are generally prepared by dissolving a solute of known mass into a solvent to a precise volume, or by diluting a solution of known concentration with more solvent. [1] A standard solution ideally has a high degree of purity and is stable enough that the concentration can be accurately measured after a long shelf time. [2]
To find the limiting reagent and the mass of HCl produced by the reaction, we change the above amounts by a factor of 90/324.41 and obtain the following amounts: 90.00 g FeCl 3, 28.37 g H 2 S, 57.67 g Fe 2 S 3, 60.69 g HCl. The limiting reactant (or reagent) is FeCl 3, since all 90.00 g of it is used up while only 28.37 g H 2 S are consumed.
For alkaline solutions, an additional term is added to the mass-balance equation for hydrogen. Since the addition of hydroxide reduces the hydrogen ion concentration, and the hydroxide ion concentration is constrained by the self-ionization equilibrium to be equal to K w [ H + ] {\displaystyle {\frac {K_{w}}{{\ce {[H+]}}}}} , the resulting ...
In chemistry, a reagent (/ r i ˈ eɪ dʒ ən t / ree-AY-jənt) or analytical reagent is a substance or compound added to a system to cause a chemical reaction, or test if one occurs. [1] The terms reactant and reagent are often used interchangeably, but reactant specifies a substance consumed in the course of a chemical reaction. [ 1 ]
When the difference between successive pK a values is less than about 3, there is overlap between the pH range of existence of the species in equilibrium. The smaller the difference, the more the overlap. In the case of citric acid, the overlap is extensive and solutions of citric acid are buffered over the whole range of pH 2.5 to 7.5.
The solubility of a specific solute in a specific solvent is generally expressed as the concentration of a saturated solution of the two. [1] Any of the several ways of expressing concentration of solutions can be used, such as the mass, volume, or amount in moles of the solute for a specific mass, volume, or mole amount of the solvent or of the solution.
This difference arises from acid/base reactions between protic solvents (not aprotic solvents) and strong nucleophiles. While it is true that steric effects also affect the relative reaction rates, [ 12 ] however, for demonstration of principle for solvent polarity on S N 2 reaction rates, steric effects may be neglected.