Search results
Results from the WOW.Com Content Network
In a system using segmentation, computer memory addresses consist of a segment id and an offset within the segment. [3] A hardware memory management unit (MMU) is responsible for translating the segment and offset into a physical address, and for performing checks to make sure the translation can be done and that the reference to that segment and offset is permitted.
Overlays are not a method of paging RAM to disk but merely of minimizing the program's RAM use. Subsequent architectures used memory segmentation, and individual program segments became the units exchanged between disk and RAM. A segment was the program's entire code segment or data segment, or sometimes other large data structures.
If the paging unit is enabled, addresses in a segment are now virtual addresses, rather than physical addresses as they were on the 80286. That is, the segment starting address, the offset, and the final 32-bit address the segmentation unit derived by adding the two are all virtual (or logical) addresses when the paging unit is enabled.
The 80286 added an MMU that supports segmentation, but not paging. When segmentation is enabled by turning on protected mode, the segment number acts as an index into a table of segment descriptors; a segment descriptor contains a base physical address, a segment length, a presence bit to indicate whether the segment is currently in memory ...
Illegal accesses and invalid page faults can result in a segmentation fault or bus error, resulting in an app or OS crash. Software bugs are often the causes of these problems, but hardware memory errors, such as those caused by overclocking, may corrupt pointers and cause valid code to fail.
There is normally one hash table, contiguous in physical memory, shared by all processes. A per-process identifier is used to disambiguate the pages of different processes from each other. It is somewhat slow to remove the page table entries of a given process; the OS may avoid reusing per-process identifier values to delay facing this.
In computing, a segmentation fault (often shortened to segfault) or access violation is a fault, or failure condition, raised by hardware with memory protection, notifying an operating system (OS) the software has attempted to access a restricted area of memory (a memory access violation).
Most computer architectures which support paging also use pages as the basis for memory protection. A page table maps virtual memory to physical memory. There may be a single page table, a page table for each process, a page table for each segment, or a hierarchy of page tables, depending on the architecture and the OS.