Search results
Results from the WOW.Com Content Network
Murphy oil pressure gauges with switches that activate on low pressure. Oil pressure is an important factor in the longevity of most internal combustion engines. [1] With a forced lubrication system (invented by Frederick Lanchester), oil is picked up by a positive displacement oil pump and forced through oil galleries (passageways) into bearings, such as the main bearings, big end bearings ...
Indications of low oil pressure may be that the warning light is on, a low pressure reading on the gauge, or clattering/clinking noises from the engine. Low oil pressure is a problem that must be addressed immediately to prevent serious damage. The leading cause of low oil pressure in an engine is wear on the engine's vital parts.
When a tire is under-inflated, it causes the inside of the tire to heat up. This heat compromises the internal structure of the tire which can lead to a blowout. When a tire is over-inflated, it wears the tread down faster, and becomes more prone to catching nails or screws in the tire. The best way to check tire maintenance is to check the air ...
In the tire factory, the tire and wheel are mounted on a balancing machine test wheel, the assembly is rotated at 100 r/min (about 5–7 m/s (18–25 km/h; 11–16 mph) with recent high sensitivity sensors) or higher, 300 r/min (about 25–27 m/s (90–97 km/h; 56–60 mph) with typical low sensitivity sensors), and forces of unbalance are ...
Underinflated tires wear out faster and lose energy to rolling resistance because of tire deformation. The loss for a car is approximately 1.0 percent for every 2 psi (0.1 bar; 10 kPa) drop in pressure of all four tires. [7] Improper wheel alignment and high engine oil kinematic viscosity also reduce fuel efficiency.
Diesel engine runaway is an occurrence in diesel engines, in which the engine draws extra fuel from an unintended source and overspeeds at higher and higher RPM, producing up to ten times the engine's rated output until destroyed by mechanical failure or bearing seizure due to a lack of lubrication. [1]
In an era when different models of car with different wheel sizes could be accommodated by simply changing the final drive ratio, it made sense for all transmissions to use direct drive as the highest gear. As noted earlier, however, this would cause the engine to operate at too high an RPM for efficient cruising.
In the past, many different types of bogie (truck) have been used under tramcars (e.g. Brill, Peckham, maximum traction). A maximum traction truck has one driving axle with large wheels and one nondriving axle with smaller wheels. The bogie pivot is located off-centre, so more than half the weight rests on the driving axle.