Search results
Results from the WOW.Com Content Network
Dual-ported RAM (DPRAM), also called dual-port RAM, is a type of random-access memory (RAM) that can be accessed via two different buses.. A simple dual-port RAM may allow only read access through one of the ports and write access through the other, in which case the same memory location cannot be accessed simultaneously through the ports since a write operation modifies the data and therefore ...
Dual-ported video RAM (VRAM) is a dual-ported RAM variant of dynamic RAM (DRAM), which was once commonly used to store the Framebuffer in Graphics card, . Dual-ported RAM allows the CPU to read and write data to memory as if it were a conventional DRAM chip, while adding a second port that reads out data.
A CPU cache is a hardware cache used by the central processing unit (CPU) of a computer to reduce the average cost (time or energy) to access data from the main memory. [1] A cache is a smaller, faster memory, located closer to a processor core, which stores copies of the data from frequently used main memory locations.
It adds functions such as bit masking (writing to a specified bit plane without affecting the others) and block write (filling a block of memory with a single colour). Unlike VRAM and WRAM, SGRAM is single-ported. However, it can open two memory pages at once, which simulates the dual-port nature of other video RAM technologies.
Dual-channel memory slots, color-coded orange and yellow for this particular motherboard. Dual-channel-enabled memory controllers in a PC system architecture use two 64-bit data channels. Dual-channel should not be confused with double data rate (DDR), in which data exchange happens twice per DRAM clock. The two technologies are independent of ...
A memory rank is a set of DRAM chips connected to the same chip select, which are therefore accessed simultaneously. In practice all DRAM chips share all of the other command and control signals, and only the chip select pins for each rank are separate (the data pins are shared across ranks).
PC-800 RDRAM operated at 400 MHz and delivered 1600 MB/s of bandwidth over a 16-bit bus. It was packaged as a 184-pin RIMM (Rambus in-line memory module) form factor, similar to a DIMM (dual in-line memory module). Data is transferred on both the rising and falling edges of the clock signal, a technique known as DDR. To emphasize the advantages ...
30-pin SIMM, 256 KB capacity Two 30-pin SIMM slots on an IBM PS/2 Model 50 motherboard. Standard sizes: 256 KB, 1 MB, 4 MB, 16 MB. 30-pin SIMMs have 12 address lines, which can provide a total of 24 address bits. With an 8-bit data width, this leads to an absolute maximum capacity of 16 MB for both parity and non-parity modules (the additional redundancy-bit chip usually doe