enow.com Web Search

  1. Ad

    related to: bad power supply or motherboard error message on laptop hp

Search results

  1. Results from the WOW.Com Content Network
  2. Power good signal - Wikipedia

    en.wikipedia.org/wiki/Power_good_signal

    The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.

  3. Power-on self-test - Wikipedia

    en.wikipedia.org/wiki/Power-on_self-test

    Power supply may be bad Long continuous beep tone Memory failure Steady, long beeps Power supply bad No beep Power supply bad, system not plugged in, or power not turned on No beep If everything seems to be functioning correctly there may be a problem with the 'beeper' itself. The system will normally beep one short beep. One long, two short beeps

  4. Built-in self-test - Wikipedia

    en.wikipedia.org/wiki/Built-in_self-test

    Unattended machinery performs self-tests to discover whether it needs maintenance or repair. Typical tests are for temperature, humidity, bad communications, burglars, or a bad power supply. For example, power systems or batteries are often under stress, and can easily overheat or fail. So, they are often tested.

  5. ATX - Wikipedia

    en.wikipedia.org/wiki/ATX

    PS_ON# (power on) is a signal from the motherboard to the power supply. When the line is connected to ground (by the motherboard), the power supply turns on. It is internally pulled up to +5 V inside the power supply. [3] [19] PWR_OK ("power good") is an output from the power supply that indicates that its output has stabilized and is ready for ...

  6. Power supply unit (computer) - Wikipedia

    en.wikipedia.org/wiki/Power_supply_unit_(computer)

    The desktop computer power supply converts the alternating current (AC) from a wall socket of mains electricity to a low-voltage direct current (DC) to operate the motherboard, processor and peripheral devices. Several direct-current voltages are required, and they must be regulated with some accuracy to provide stable operation of the computer.

  7. Voltage regulator module - Wikipedia

    en.wikipedia.org/wiki/Voltage_regulator_module

    A voltage regulator module (VRM), sometimes called processor power module (PPM), is a buck converter that provides the microprocessor and chipset the appropriate supply voltage, converting +3.3 V, +5 V or +12 V to lower voltages required by the devices, allowing devices with different supply voltages be mounted on the same motherboard.

  8. College Football Playoff quarterfinal schedule, matchups ...

    www.aol.com/sports/college-football-playoff-odds...

    College Football Playoff quarterfinals Fiesta Bowl. No. 6 Penn State vs. No. 3 Boise State. Date: Dec. 31 | Time: 7:30 p.m. ET | TV: ESPN | Line: Penn State -10.5 | Total: 52.5 The Nittany Lions ...

  9. Brownout (electricity) - Wikipedia

    en.wikipedia.org/wiki/Brownout_(electricity)

    A switched-mode power supply will be affected if the brownout voltage is lower than the minimum input voltage of the power supply. As the input voltage falls, the current draw will increase to maintain the same output voltage and current, until such a point that the power supply malfunctions or its under-voltage protection kicks in and disables ...

  1. Ad

    related to: bad power supply or motherboard error message on laptop hp