Search results
Results from the WOW.Com Content Network
An electrical grid may have many types of generators and loads; generators must be controlled to maintain stable operation of the system. In an electric power system, automatic generation control (AGC) is a system for adjusting the power output of multiple generators at different power plants, in response to changes in the load. Since a power ...
Adjustments in power output for a particular primer mover and generator combination are made by slowly raising the droop curve by increasing the spring pressure on a centrifugal governor or by an engine control unit adjustment, or the analogous operation for an electronic speed governor. All units to be connected to a grid should have the same ...
A power conditioner (also known as a line conditioner or power line conditioner) is a device intended to improve the quality of the power that is delivered to electrical load equipment. The term most often refers to a device that acts in one or more ways to deliver a voltage of the proper level and characteristics to enable load equipment to ...
Before, fixed-speed on/off compressors required an inrush, or surge, current that was 4 to 6 times greater than the running current at startup, meaning a requirement of 4 to 6 times more solar panels or batteries. Inverter compressors start slowly and avoid this startup power which is needed each time a standard on/off compressor comes on.
Hydrogen-cooled turbo generator's cooling can be improved by increasing the hydrogen pressure, larger generators, from 300 MVA, use more efficient water cooling. [3] Capability curve of a synchronous generator with minimum load. The practical D-curve of a typical synchronous generator has one more limitation, minimum load. The minimum real ...
The water temperature drops below the critical point as it does work in a high pressure turbine and enters the generator's condenser, resulting in slightly less fuel use. The efficiency of power plants with supercritical steam generators is higher than with subcritical steam because thermodynamic efficiency is directly related to the magnitude ...
S-turbines eliminate the need for a bulb housing by placing the generator outside of the water channel. This is accomplished with a jog in the water channel and a shaft connecting the runner and generator. The VLH turbine is an open flow, very low head "kaplan" turbine slanted at an angle to the water flow. It has a large diameter >3.55 m, is ...
The energy for the water main in this case was not created by gravity, but the water was pumped by a larger steam engine at a water pumping station to supply water to customers. The decision to have water pumped by a larger engine then take some of the energy from water flow to power a smaller generator using water wheel was based on the cost.