enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drywall - Wikipedia

   en.wikipedia.org/wiki/Drywall

   Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...

3. What's the Actual Difference Between Sheetrock and Drywall? - AOL

   www.aol.com/whats-actual-difference-between...

   Drywall is a flat construction material that's used to create walls, ceilings, and ... Size and Thickness. Drywall boards ... 5/8-inch drywall is often fire resistant and is the best choice for ...

4. Magnesium oxide wallboard - Wikipedia

   en.wikipedia.org/wiki/Magnesium_oxide_wallboard

   Magnesium oxide wallboard (10 mm thickness) Magnesium oxide, more commonly called magnesia, is a mineral that when used as part of a cement mixture and cast into thin cement panels under proper curing procedures and practices can be used in residential and commercial building construction. Some versions are suitable for general building uses ...

5. Plaster veneer - Wikipedia

   en.wikipedia.org/wiki/Plaster_veneer

   It is recommended to wait 28 days before painting a lime finish wall. However this wait time can be shortened by using an oil based primer once the plaster is dry. [ 6 ] Plastering walls with one coat is actually faster than taping since you don't have to wait for three separate coats to dry for 24 hours, as in taping.

6. Lath and plaster - Wikipedia

   en.wikipedia.org/wiki/Lath_and_plaster

   Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1]

7. Lath - Wikipedia

   en.wikipedia.org/wiki/Lath

   Metal lath and plaster walls can be twice as resistant to fire as drywall, and are capable of achieving a two-hour fire rating with a 2-inch-thick (5.1 cm) assembly. Two inches of plaster and lath can also achieve the same decibel rating as 4 + 7 ⁄ 8 inches (12 cm) of drywall. [15]

8. Vapor barrier - Wikipedia

   en.wikipedia.org/wiki/Vapor_barrier

   Vapor retarder paints (for the air-tight drywall system, for retrofits where finished walls and ceilings will not be replaced, or for dry basements: can break down over time due to being chemically based). Extruded polystyrene or foil-faced foam board insulation. Exterior grade plywood, 0.70 US perm (40 SI perm).

9. Gypsum block - Wikipedia

   en.wikipedia.org/wiki/Gypsum_block

   A gypsum block is made of gypsum plaster and water. The manufacturing process [1] is automated at production plants where raw gypsum (CaSO 4 ·2H 2 O) is ground and dried, then heated to remove three-quarters of the bound water and thus transformed into calcium sulfate hemihydrate (CaSO 4 ·½H 2 O), also known as gypsum plaster, stucco, calcined gypsum or plaster of Paris.