Search results
Results from the WOW.Com Content Network
Husky is a line of hand tools, pneumatic tools, and tool storage products. Though founded in 1924, it is now best known as the house brand of The Home Depot, where it is exclusively sold. Its hand tools are manufactured for Home Depot by Western Forge, Apex Tool Group, and Iron Bridge Tools. [1] Its slogan is "The toughest name in tools."
The Detroit Diesel 149 is a series of two-stroke diesel engines manufactured by Detroit Diesel which were first announced in early 1966. After Detroit Diesel was spun off in 1988 and later acquired by MTU, production of Series 149 engines was discontinued around 2000.
On engines that use a carburetor (e.g. in older cars, lawnmowers and power tools), a mechanical fuel pump is typically used in order to transfer fuel from the fuel tank into the carburetor. These fuel pumps operate at a relatively low fuel pressure of 10–15 psi (0.7–1.0 bar).
The connectors are designed for 12V systems. Exceptions for the 7-pin connector may exist where they may be used for 6V and 24V. Vehicles and trailers with 6V systems can use the 7-pin or a 5-pin connector, but these are rare today. Heavy trucks that may have 12V systems are usually older (vintage vehicles) or on non-European markets. [1]
Fuel-saving devices are sold on the aftermarket with claims they may improve the fuel economy, the exhaust emissions, or optimize ignition, air flow, or fuel flow of automobiles in some way. An early example of such a device sold with difficult-to-justify claims is the 200 mpg ‑US (1.2 L/100 km) carburetor designed by Canadian inventor ...
The inline six-cylinder 71 series engine was introduced as the initial flagship product of the Detroit Diesel Engine Division of General Motors in 1938.. This engine was in high demand during WWII, necessitating a dramatic increase in output: about 57,000 6-71s were used on American landing craft, including 19,000 on LCVPs, about 8,000 on LCM Mk 3, and about 9,000 in quads on LCIs; and 39,000 ...
Bipolar plate Bipolar plate, conductive plate in a fuel-cell stack that acts as an anode for one cell and a cathode for the adjacent cell. The plate may be made of metal or a conductive polymer (which may be a carbon-filled composite). The plate usually incorporates flow channels for the fluid feeds and may also contain conduits for heat transfer.
The surface plate is often used as the baseline for all measurements to a workpiece, therefore one primary surface is finished extremely flat with tolerances below 11.5 μm or 0.0115 mm per 2960 mm for a grade 0 plate. [2] Surface plates are a common tool in the manufacturing industry and are often fitted with mounting points so that it can be ...