Search results
Results from the WOW.Com Content Network
≡ 1 atm × 1 cm 3 = 0.101 325 J: cubic foot of atmosphere; standard cubic foot: cu ft atm; scf ≡ 1 atm × 1 ft 3 = 2.869 204 480 9344 × 10 3 J: cubic foot of natural gas: ≡ 1000 BTU IT = 1.055 055 852 62 × 10 6 J: cubic yard of atmosphere; standard cubic yard: cu yd atm; scy ≡ 1 atm × 1 yd 3 = 77.468 520 985 2288 × 10 3 J ...
One GGE of natural gas is 126.67 cubic feet (3.587 m 3) at standard conditions. This volume of natural gas has the same energy content as one US gallon of gasoline (based on lower heating values: 900 BTU/cu ft (9.3 kWh/m 3) of natural gas and 114,000 BTU/US gal (8.8 kWh/L) for gasoline). [22]
The Winchester bushel is the volume of a cylinder 18.5 in (470 mm) in diameter and 8 in (200 mm) high, which gives an irrational number of approximately 2150.4202 cubic inches. [4] The modern American or US bushel is a variant of this, rounded to exactly 2150.42 cubic inches, less than one part per ten million less. [ 5 ]
All this because of the lack in ability to do this simple calculation. I will illustrate here: 1 acre (1 foot thick) x # of gallons in a cubic foot. This is, simply 43560 (Cubic feet) x 7.48 gallons / cubic foot = 325,828.8 gallons - rounded to 325,829 gallons per acre foot (do it on a calculator!).
If one pallet uses approximately 175 linear feet of film, a 40 x 48 inch pallet 6 feet tall will hold 80 cubic feet or 360 gallons of milk (given 4.5 gallons of milk per cubic foot), and require 1,056 square feet of film, equaling just under 3 square feet of film per gallon. [5]
Using data from Numbeo, we compiled a list that lays out the average cost for a gallon of milk in 12 different US cities, from most expensive to the cheapest. To our surprise, the difference in ...
In fact, a gallon of 2% has more than half the fat as a gallon of whole milk. The FDA requires whole milk to have at least 3.25$ fat by weight. But the amount of fat can range from 3.25$ to 5 ...
The IEEE symbol for the cubic foot per second is ft 3 /s. [1] The following other abbreviations are also sometimes used: ft 3 /sec; cu ft/s; cfs or CFS; cusec; second-feet; The flow or discharge of rivers, i.e., the volume of water passing a location per unit of time, is commonly expressed in units of cubic feet per second or cubic metres per second.