Search results
Results from the WOW.Com Content Network
Typical lectromechanical Universal Testing Machine Test fixture for three point flex test. A universal testing machine (UTM), also known as a universal tester, [1] universal tensile machine, materials testing machine, materials test frame, is used to test the tensile strength (pulling) and compressive strength (pushing), flexural strength, bending, shear, hardness, and torsion testing ...
The construction industry is often involved in a wide array of testing. In addition to simple compression testing, testing standards such as ASTM C39, ASTM C109, ASTM C469, ASTM C1609 are among the test methods that can be followed to measure the mechanical properties of concrete.
Rockwell hardness test (HR), principally used in the USA; Shore durometer hardness, used for polymers; Barcol hardness test, for composite materials; Tensile testing, used to obtain the stress-strain curve for a material, and from there, properties such as Young modulus, yield (or proof) stress, tensile stress and % elongation to failure ...
In heating, ventilation, and air conditioning (HVAC), testing, adjusting and balancing (TAB) are the three major steps used to achieve proper operation of heating, ventilation, and air conditioning systems. TAB usually refers to commercial building construction and the specialized contractors who employ personnel that perform this service.
A general note applies generally and is not called out with flags. 2. Find number: "FN" meaning "find number" refers to the ordinal number that gives an ID tag to one of the constituents in a parts list (list of materials, bill of materials). Thus "fasten using FN7" refers to a fastener that is "find number" 7 in the list. FoS: feature of size
It is also used in testing a specimen, for a process where the crosshead moves to load the specimen to a specified value before a test starts. Data is not captured during the preload segment. When tensile specimens are initially placed into testing grips, they can be subjected to small compressive forces. These forces can cause specimens to ...
Characterization, when used in materials science, refers to the broad and general process by which a material's structure and properties are probed and measured. It is a fundamental process in the field of materials science, without which no scientific understanding of engineering materials could be ascertained.
Also Abrams' water-cement ratio law. A law which states that the strength of a concrete mix is inversely related to the mass ratio of water to cement. As the water content increases, the strength of the concrete decreases. abrasion The process of scuffing, scratching, wearing down, marring, or rubbing away a substance or substrate. It can be intentionally imposed in a controlled process using ...