Search results
Results from the WOW.Com Content Network
A linear drain A Channel Drain. There are four common types of trench drains which are based on forming or installation method. These are cast-in-place, pre-cast concrete, liner systems and former systems. Newer stainless steel drains are available for residential and commercial shower installs and more commonly called "channel drains".
The two stage drainage ditch is classified as a 'surface' sustainable drainage system, contrary to a sub-surface system. The two stage drainage ditch is a modification of the land whereby grass benches which serve as floodplains are formed within the land of the watershed of the water system, shown in the diagram to the right. [1]
A percolation trench is similar to a dry well, which is typically an excavated hole filled with gravel. [3] Another similar drainage structure is a French drain, which directs water away from a building foundation, but is usually not designed to protect water quality.
A diagram of a traditional French drain. A French drain [1] (also known by other names including trench drain, blind drain, [1] rubble drain, [1] and rock drain [1]) is a trench filled with gravel or rock, or both, with or without a perforated pipe that redirects surface water and groundwater away from an area.
A French drain, PVC pipe, or other drainage system is installed in the newly made channel. The installed drain is covered with new cement. The installed drain is covered with new cement. The drainage system collects any water entering the basement and drains it to an internally placed sump pump system, which will then pump the water out of the ...
In geotechnical engineering, an interceptor ditch is a small ditch or channel constructed to intercept and drain water to an area where it can be safely discharged. [1] These are used for excavation purposes of limited depth made in a coarse-grained soils. These are constructed around an area to be dewatered.
The interception rate of channel drainage is greater than point drainage and the excavation required is usually much less deep. The surface opening of channel drainage usually comes in the form of gratings (polymer, plastic, steel or iron) or a single slot (slot drain) that run along the ground surface (typically manufactured from steel or iron).
Storm water is typically channeled to a retention basin through a system of street and/or parking lot storm drains, and a network of drain channels or underground pipes.. The basins are designed to allow relatively large flows of water to enter, but discharges to receiving waters are limited by outlet structures that function only during very large storm eve