Search results
Results from the WOW.Com Content Network
Although it displaces 134 cu. in, the 2.2-liter OHV is still commonly referred to as the GM 122 today, and has been reputed for its simplicity, reliability, and ease of maintenance in the J-body cars and S-series trucks, and a few L-body cars. The 2003 model LN2 is equipped with secondary air injection. [1] Applications: 1993–1996 Buick Century
There is essentially no difference in efficiency between the technique of bypassing the throttle butterfly and operating the butterfly itself. The IAC allows the ECU to maintain minimum RPM irrespective of changes in engine load, sometimes referred to as anti-stall feature. Thus the driver can more easily move the car from stand-still by merely ...
Other problems may be implicated in the case of older vehicles equipped with carburetors. Weak, disconnected, or mis-connected throttle return springs, worn shot-pump barrels, chafed cable housings, and cables which jump their tracks in the throttle-body crank can all cause similar acceleration problems.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
A unique intake manifold that used the 48 mm (1.9 in) twin-bore throttle body from the 5.7L TPI Corvette engine was used on the engine's top end. [9] The turbocharged 4.3 L (262 cu in) was last used in the GMC Typhoon in the 1993 model year. The engine produced 280 hp (209 kW) at 4400 rpm and 360 lb⋅ft (488 N⋅m) of torque at 3600 rpm.
The 267 was introduced in 1979 for the GM F-body (Camaro), G-body (Chevrolet Monte Carlo, El Camino), A-body (Malibu Classic, 1979–1981) and also used on GM B-body cars (Impala and Caprice models). The 4.4 L; 267.8 cu in (4,389 cc) engine had the 350's crankshaft stroke of 3.48 in (88.4 mm) and the smallest bore of any small-block, 3.5 in (88 ...
GM CFO Paul Jacobson added that launching and operating a robotaxi service would take a significant amount of capital, beyond the $10 billion or so GM already spent on Cruise.
It featured the same multiport fuel injection intake manifolds and throttle body as the LH0, and produced 205 hp (153 kW) at 5200 rpm and 225 lb⋅ft (305 N⋅m) of torque at 2100 rpm. Around 3,700 engines were produced each year. This engine had a block with more nickel content and hardened internals. Applications: