Search results
Results from the WOW.Com Content Network
AMC 20s have an 8 7/8" ring gear and use a 29 spline axle shaft. The AMC 20 was most often used with V8 engines in cars and Jeeps . It was also used in the AM General Humvee .
1984-1997 Jeep Wagoneer; 1984-2001 Jeep Cherokee; 1993-2004 Jeep Grand Cherokee; 1986-1992 Jeep Comanche; 1987-1995 Jeep YJ Wrangler Note: there was no 96 model. 1997-2006 Jeep TJ Wrangler *option Dana 44 rear and Rubicon's had Dana 44's; 2007 only some early Jeep JK 2 door Wranglers had Dana 35 non c-clip axles. 2001-2007 Jeep Liberty; Dodge ...
Dana 61 axle tag showing 3.73:1 ratio [1] The Dana 61 was made in semi-float and full-float axles for select 4×2 and 4x4 Ford 3 ⁄ 4-ton and 1 Ton Pickups and Vans from 1974 to 1987. A Dana 61 front axle was selectively used in Dodge 4×4 3 ⁄ 4-ton and 1 Ton pickups from 1987 to 1993. Although 3.07:1 and 3.31:1 gear sets are common for a ...
The Dana 44 rear axle first saw use in the 1940s and is still in use today. The Dana 44 has a GAWR up to 3,500 lb (1,600 kg) and is a semi-floating type, having one bearing on the end of the axle shaft which carries the weight of the vehicle on the axle and also allows axle rotation.
The final drive ratios of the CJ-7 were different for each type of engine: the 145 cu in (2.4 L) diesel was mated to the 4.10 ratio axle (in both Renegade and Laredo), while the 258 cubic-inch straight six and 150 cubic-inch four-cylinder used 3.73 and AMC V8 304-powered models (produced 1976–1981, which became part of the Golden Eagle ...
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
The ID number C300-15 is stamped on the case. The output for the front drive shaft is on the right side and the rear output in line with the input. Low range is 2.62:1. One common modification of the Dana 300 is to add oil paddles to the main shaft to prevent oil starvation of the rear bearing. The Dana 300 was used in Jeep CJs from 1980 to 1986.
When in "4-Low" mode the front and rear axles are locked together and power is sent to all four-wheels through a 2.92:1 gear reduction in the power transfer unit; providing a crawl ratio of 56:1 for four cylinder Jeep Cherokees and a 47.8:1 crawl ratio for six-cylinder Cherokees. All Cherokees with this system have a raised ride height of one inch.