Search results
Results from the WOW.Com Content Network
Exterior insulation and finish system (EIFS) is a general class of non-load bearing building cladding systems that provides exterior walls with an insulated, water-resistant, finished surface in an integrated composite material system. EIFS has been in use since the 1960s in North America and was first used on masonry buildings.
Cladding applied to exterior window and door casing (brick-moulding) and their associated parts is often referred to as window capping or window cladding. This sort of capping is typically applied in order to eliminate the need to re-paint wood window trim. The aluminum capping helps to prevent wood rot by protecting the wood from water and ...
Stucco used as an exterior coating on a residential building. Rock dash stucco used as an exterior coating on a house on Canada's west coast. The chips of quartz, stone, and colored glass measure approx. 3–6 mm (1/8–1/4"). The basic composition of stucco is lime, water, and sand. [4]
Caulk (also known as caulking and calking) [1] is a material used to seal joints or seams against leakage in various structures and piping. The oldest form of caulk consisted of fibrous materials driven into the wedge-shaped seams between boards on wooden boats or ships. Cast iron sewerage pipes were formerly caulked in a similar way.
Pebbledash Pebbledashing Rock dash stucco. Roughcast or pebbledash is a coarse plaster surface used on outside walls that consists of lime and sometimes cement mixed with sand, small gravel and often pebbles or shells. [1] The materials are mixed into a slurry and are then thrown at the working surface with a trowel or scoop.
In the 17th century glazing putty was first used to seal window glass made with linseed oil and chalk, later other drying oils were also used to make oil-based putties. [4] In the 1920s, polymers such as acrylic polymers, butyl polymers and silicone polymers were first developed and used in sealants. By the 1960s, synthetic-polymer-based ...
Stucco marble was an artificial marble made using gypsum (sometimes with lime), pigments, water and glue. Stucco lustro was another a form of imitation marble (sometimes called stucco lucido) where a thin layer of lime or gypsum plaster was applied over a scored support of lime, with pigments scattered on surface of the wet plaster.
Hand split lath is not uniform like sawn lath. The straightness or waviness of the grain affected the thickness or width of each lath, and thus the spacing of the lath. The clay plaster rough coat varied to cover the irregular lath. Window and door trim as well as the mudboard (baseboard) acted as screeds.